Use and Care Manual

12
OPERATING INSTRUCTIONS
CONTROL PANEL AND REMOTE OVERVIEW
The following diagram and legend shows the functions of both the unit’s control panel and the remote con-
troller. Some functions are only available on select models.
2
8
3
45
67 19
10
TEMP
COOL
AUTO
DRY
HEAT
HIGH
FAN
MED
LOW
MODE
FAN SPEED
SWING
SLEEP
TIMER ON
ON/OFF
RESET LOCK
TIMER OFF
LED
SET TEMPERATURE( F)
DISPLAY
PMTS
B
D
E F
G
H
I
J
K
L
M
N
C
O
1) ON/OFF BUTTON
Machine will start and stop when this button is pressed.
2) TEMPERATURE UP BUTTON
Push this button to increase the indoor
temperature setting in 2°F increments to 88°F.
3) TEMPERATURE DOWN BUTTON
Push this button to decrease the indoor
temperature setting in 2°F increments to 62°F.
4) MODE BUTTON
Each time the button is pressed, the operating mode of the air condi-
tioning unit is selected in the following sequence: AUTO > COOL > DRY >
HEAT* > FAN
5) FAN SPEED BUTTON
Adjust the machine fan speed from:
AUTO > LOW > MED > HIGH
6) TIMER ON BUTTON (REMOTE*)
Press this button to activate Auto-On. This feature turns on the unit at a
programmed time within the next 24 hours.
Each press of the Timer-On button will increase the time setting in 30
minutes increments, up to 10 hours, then in 1 hour increments from 10 to
24 hours. To cancel the Auto-On time setting, just press the button until
the time setting is 0.
7) TIMER OFF BUTTON (REMOTE*)
Press this button to activate Auto-O. This feature turns o the unit at a
programmed time within the next 24 hours.
Each press of the Timer-O button will increase the time setting in 30
minutes increments, up to 10 hours, then in 1 hour increments from 10 to
24 hours. To cancel the Auto-O time setting, just press the button until
the time setting is 0.
8) SLEEP (ECONOMY MODE) BUTTON
Select this function just before going to sleep. It maintains a comfortable
temperature through the night and save energy. This function is available
on COOL, HEAT* or AUTO modes only.
9)SWING BUTTON
Used to start and stop the function of the rotating directional and set the
desired air ow direction.
10) DIGITAL DISPLAY
2-Digit LED display for the unit and LCD with additional indicators for the
remote controller.
11) RESET BUTTON
Once the recessed RESET button is pressed, all of the current settings
will be canceled and the controller will return to default settings. (A
paper-clip or similar instrument is required.)
12) LOCK BUTTON
Lock the remote from accidental changes by pressing the lock button.
Disable by pressing the button. (A paper-clip or similar instrument is
required.)
13) LED DISPLAY BUTTON**
Turns the temperature display on the unit on and o.
14) PMTS (FOLLOW ME) TEMPERATURE BUTTON
PMTS means Personal Mapping Temperature Sensor. This feature uses
the remote controller to monitor temperature in another location of the
room and sends information to the unit every 3 minutes.
*On the unit itself, the single “TIMER” button serves
the function of both the “TIMER ON” and “TIMER OFF”
buttons.
**NOT AVAILABLE ON ALL UNITS