Use and Care Manual

INSTALLATION INSTRUCTIONS(optional)

Installation in a sliding sash window

1. Cut the foam seal(adhesive type) to the proper length and

attach it to the window frame. See Fig.12.

2. Attach the window slider kit to the window stool. Adjust the

length of the window slider kit according to the width of

window, shorten the adjustable window kit if the width of

window is less than 26.5 (Type I) or 22.1 (Type II) inches.

Open the window sash and place the window slider kit on

the window stool. See Fig.13.

3. Cut the foam seal(adhesive type) to the proper length

and attach it on the top of the window. Shown as in Fig.14.

4. Close the sliding sash securely against the window.

5. Cut the foam seal to an appropriate length and sea the

open gap between the top window sash and outer window

sash. Shown as in Fig.15.

Foam seal

Foam seal A

(adhesive type)

Fig.12

Fig.13

Fig.14

Fig.15

Window

panel

NOTE:All the illustrations in this manual are for explanation

purpose only.Your unit may be slightly different. The

actual shape shall prevail.

22.1 ~ 38.6

Type I

Type II

26.5 ~ 48.0