User guide

ENGLISH
–15–
3. Align the hole in the top rail with those in
the top of the unit as shown in Figure B.
4. Secure the top rail to the unit with the ⅜”
screws as shown in Figure C.
Note: For safety reasons, all four (4) screws
MUST be securely fastened.
SIDE PANEL INSTALLATION
NOTE: Top rail and Sliding Panels at each side are oset to provide the proper pitch to the rear of
the unit (5/16”). This is necessary for proper condensed water utilization and drainage. If you are
not using the Side Panels for any reason, this pitch to the rear must be maintained.
1. Place unit on the floor, a bench, or a table. There is a Le and Right Window Filler Panel—be
sure to use the proper panel for each side. When installed, the flange for securing the panel in
place to the windowsill will be facing into the room.
Hold the Accordion Panel in one hand
and gently pull back the center to free the
open end. See Figure 2
Slide the free end of the panel
into the cabinet as shown in Fig-
ure 3A, 3B, and 3C. Slide the pan-
el down. Be sure to leave enough
space to slip the top and bottom
of the frame into the rails on the
cabinet.