User guide

ENGLISH
–10–
PMTS — FOLLOW ME
Personal Mapping Temperature Sensor: Your model may be
equipped with a special feature that allows the remote control to
act as a thermostat. If your unit shows this PMTS LED on the control
panel, and you have the accompanying LCD remote control then
your unit is equipped.
You must activate this feature through the remote control by press-
ing the PMTS button. Once activated, it is important to keep the
remote aimed at the air conditioner and place it in the center of the
room for best results.
ENERGY SAVER MODE
This function is available on COOL mode. The fan will continue
to run for 3 minutes aer the compressor shuts o. The fan then
cycles on for 2 minutes at 10-minute intervals until the room tem-
perature is above the set temperature, at which time the compres-
sor turns back on and Cooling Starts. Note that due to modern
energy saving regulations, this mode is on by default and you
must turn it o if you want the fan to run constantly during cooling
mode.
SLEEP MODE
While in cooling mode, this function will cause the selected tem-
perature to increase by 2°F (or 2°C) 30 minutes aer the function
is selected. The temperature will then increase by another 2°F (or
2°C) aer an additional 30 minutes. This new temperature will be
maintained for 6 hours before it returns to the originally selected
temperature. This ends the Sleep mode and the unit will continue
to operate as originally programmed. While in heating mode, the
sleep function will perform the same function in reverse by de-
creasing the temperature by 2°F (or 2°C), for 30 minutes, etc. The
Sleep mode program can be canceled at any time during opera-
tion by pressing the Sleep button again.
CHECK FILTER
This feature is a reminder to clean the Air Filter for more eicient
operation. The LED (light) will illuminate aer 250 hours of opera-
tion. To reset aer cleaning the filter, press the Check Filter button
and the light will go o. See section under Cleaning and Mainte-
nance for how to clean the filter.
Note: Your filter may need to be cleaned much more oen in especially
dusty environments and may not need to be cleaned as oen in especial-
ly clean environments. The 250 hour indicator is just there as a reminder.
Ion

Heat
PMTS
PMTS

PMTS
