Select 10 1900-10 Installation Instructions & Warranty Information 425 Apollo Street Brea, CA 92821 www.imperialhoods.
Imperial Cal Products, Inc. Read Before Starting Installation! Inspect your range hood prior to installing! Any cosmetic defects must be reported to us prior to installation. Once this hood is installed, ICP will NOT accept any responsibility for any cosmetic blemishes, scratches or dents in the Canopy. Save all original packaging if you wish to return for any reason! FIRST: Check your local building and electrical codes.
Select 10 Installation Details: MODELS 1900T-10 1900TB-10 1900SD2 MODELS 1900PS1-10 1900PS1B-10 (*B indicates Baffle Filters) MODELS 1900PS-10 1900PSB-10 CABINET: Be sure that the cabinet bottom is level, side to side and front to rear. PS: Cut an 8” x 8” hole in the bottom of the cabinet, 3/4” in from the rear wall and on center line. T & PS1: Cut an 8” x 8” wide hole that is 4.25” off center in the bottom of the cabinet, 3/4” in from the wall.
Installation Instructions for WALL Mounting application. 1. From bottom of hood, measure 10” up and draw a line. 2. Take “U” shape installation bracket and line the bottom of the bracket up with the line (center bracket left to right) install bracket using #10 x 2-1/2” wood screws, if you have wood to screw in to. If not use the 3/16” x 3” toggle bolts. 3. Lift up hood and connect hood brackets to installation bracket using (8) 10-32 Hex Keps nuts. Make sure hood is level before you tighten all screws. 4.
Imperial Cal Products, Inc. To order replace parts or schedule service please call our office at (800) 8514192 or use our website… www.imperialhoods.com. PARTS: When ordering Parts we need the following information: Model Number (not serial number) found on UL label inside hood. Exact dimensions (in the case of filters) You can find the model number on the inside of your hood on our UL label.
Maintenance & Warranty Information This product has the simplest of cleaning requirements. To remove Baffle Filters, remove center panel by pulling panel toward the front of the hood, lift up to remove. Move filters to the center of the hood, pull baffle towards the front of the hood and lift out. To remove grease tray, slide tray to the top of the hood and lift out. Clean filters often for the best performance. How often depends on amount and type of cooking.
SAFETY INSTRUCTIONS Read and Save These Instructions Warning: To reduce the risk of fire, electrical shock or injury to persons, observe the following: A. Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock Service Disconnecting Means to prevent power from being switched on accidentally.
Mail warranty card to: Imperial Cal Products ATTN: Warranty Department 425 Apollo St. Brea, CA 92821 Or visit our website to complete warranty registration: www.imperialhoods.com Please keep receipt. Proof of original purchase date is needed to obtain service under warranty. Warranty card can be submitted via our website at: www.imperialhoods.com or by mail.