Imperial Kitchen Ventilation Flush Mount G3000 / 3000 Series Installation Instructions & Warranty Information 425 Apollo Street Brea, CA 92821 www.imperialhoods.
Read Before Starting Installation! Inspect your range hood prior to installing! Any cosmetic defects must be reported to us prior to installation. Once this hood is installed, ICP will NOT accept any responsibility for any cosmetic blemishes, scratches or dents in the Canopy. Save all original packaging if you wish to return for any reason! FIRST: Check your local building and electrical codes.
Flush Mount Installation Details: CABINET: Be sure cabinet bottom is level, side to side and front to rear. For the “SD” units prepare cabinet by cutting an 8” x 8” hole in bottom, 3/4” from wall and on Center line. For the “PS1” units prepare the cabinet by cutting a 10 3/8” (D) x 20 1/4” (W) hole in the bottom, 1/2” from wall and center line. Shelves and top to be cut to clear 7” round pipe. Also, cut holes for electrical wires.
Flush Mount Installation Details: TO REMOVE DRAWER FROM 3000 A) Pull out drawer until it stops; depress drawer top at the point indicated by arrow “A” while pulling the drawer outward. WHEN THE DRAWER STOPS AGAIN… B) Depress two black buttons indicated by arrows marked “B” while pulling the drawer outward.
To order replace parts or schedule service please call our office at (800) 851-4192. PARTS: When ordering Parts we need the following information: Model Number (not serial number) found on UL label inside hood. Exact dimensions (in the case of filters) You can find the model number on the inside of your hood on our UL label. There will be a several model numbers listed, your model number should have some kind of mark next to it to indicate the exact model you have.
Maintenance & Warranty Information This product has the simplest of cleaning requirements. To remove Baffle Filters, remove center panel by pulling panel toward the front of the hood, lift up to remove. Move filters to the center of the hood, pull baffle towards the front of the hood and lift out. To remove grease tray, slide tray to the top of the hood and lift out. Clean filters often for the best performance. How often depends on amount and type of cooking.
SAFETY INSTRUCTIONS Read and Save These Instructions Warning: To reduce the risk of fire, electrical shock or injury to persons, observe the following: A. Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock Service Disconnecting Means to prevent power from being switched on accidentally.