Flush Mount—3000 & G3000 Installation Instructions & Warranty Information 425 Apollo Street Brea, CA 92821 www.imperialhoods.com (800) 851-4192 DO NOT THROW AWAY, PROPERTY OF THE HOME OWNER! FLSH/7.
Imperial Cal Products, Inc. Read Before Starting Installation! Inspect your range hood prior to installing! Any cosmetic defects must be reported to us prior to installation. Once this hood is installed, ICP will NOT accept any responsibility for any cosmetic blemishes, scratches or dents in the Canopy. Save all original packaging if you wish to return for any reason! FIRST: Check your local building and electrical codes.
Flush Mount Installation Details: MODELS: G3000SD2 3000SD2 MODELS: G3000SD4 3000SD4 MODELS: G3000PS1 3000PS1 CABINET: Be sure cabinet bottom is level, side to side and front to rear. For the “SD” units prepare cabinet by cutting an 8” x 8” hole in bottom, 3/4” from wall and on Center line. For the “PS1” units prepare the cabinet by cutting a 10 3/8” (D) x 20 1/4” (W) hole in the bottom, 1/2” from wall and center line. Shelves and top to be cut to clear 7” round pipe.
Flush Mount Installation Details: MODELS: G3000SD2 3000SD2 MODELS: G3000SD4 3000SD4 MODELS: G3000PS1 3000PS1 TO REMOVE DRAWER FROM 3000 A) Pull out drawer until it stops. B) Press down drawer top at the point indicated by arrow “A” to release safety clip, while pulling the drawer outward. WHEN THE DRAWER STOPS AGAIN… C) Press two black buttons on left and right slides indicated by arrows marked “B” . D) Pulling the drawer outward.
Imperial Cal Products, Inc. To order replace parts or schedule service please call our office at (800) 851-4192. PARTS: When ordering Parts we need the following information: Model Number (not serial number) found on receipt of purchase or Series listed on the UL label inside hood. Filters—provide Exact Dimensions You can find the model number on the inside of your hood on our UL label.
Imperial Cal Products, Inc. Maintenance & Warranty Information This product has the simplest of cleaning requirements. Clean filters often for the best performance. May be used in the dishwasher, depending on detergents, filters may discolor. How often depends on amount and type of cooking. When cleaning a painted hood, wash it with mild, soapy water ONLY! Wipe the hood thoroughly with clean water and dry with soft cloth. When cleaning Stainless Steel use a cleaner specifically for Stainless Steel.
SAFETY INSTRUCTIONS Read and Save These Instructions Warning: To reduce the risk of fire, electrical shock or injury to persons, observe the following: A. Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock Service Disconnecting Means to prevent power from being switched on accidentally.
FLUSH MOUNT—3000 / G3000 Instructions d'installation & Informations sur la garantie 425 Rue Apollo Brea CA 92821 www.imperialhoods.
Impériale Cal Products, Inc. Lire avant de commencer l'Installation ! Inspecter avant d'installer votre hotte de cuisinière ! Les défauts cosmétiques doivent nous être signalés avant l'installation. Une fois cette hotte est installée, ICP n'acceptera aucune responsabilité pour toute les imperfections cosmétiques, rayures ou bosses dans la canopée.
Détail d'Installation Liners alimenté : MODELS: G3000SD2 3000SD2 MODELS: G3000SD4 3000SD4 MODELS: G3000PS1 3000PS1 Armoire : N'oubliez pas de dessous d'armoire est de niveau, côté à côté et en avant vers l'arrière. Pour le « SD » unités préparent l'armoire en coupant une 8 « x 8 » trou dans le fond, 3/4 po du mur et sur Ligne centrale. Pour le « PS1 » unités préparent l'armoire en coupant une 10 3/8 "(D) x 20 1/4" (L) trou dans le fond, 1/2 "de la ligne de centre et de la paroi.
Détail d'Installation Liners alimenté : MODELS: G3000SD2 3000SD2 MODELS: G3000SD4 3000SD4 MODELS: G3000PS1 3000PS1 POUR RETIRER LE TIROIR DE 3000 Sortir tiroir jusqu'à ce qu'il s'arrête ; Appuyez sur haut tiroir au point indiqué par la flèche « A », tout en tirant le tiroir vers l'extérieur. QUAND LE TIROIR S'ARRÊTE À NOUVEAU... B) appuyer sur deux boutons noirs, indiquées par les flèches marquées "B" tout en tirant le tiroir vers l'extérieur.
Impériale Cal Products, Inc. Pour commander des pièces ou annexe service, veuillez appeler notre bureau au (800) 851-4192 ou utiliser notre site Web... www.imperialhoods.com. PIÈCES : Lorsque vous commandez des pièces nous avons besoin des informations suivantes : Numéro de modèle (pas les numéro de série) sur l'étiquette d'UL à l'intérieur de la hotte. Dimensions exactes (dans le cas des filtres) Vous pouvez trouver le numéro de modèle à l'intérieur de votre hotte sur notre label UL.
Entretien & garantie Information Ce produit est le plus simple des exigences en matière de nettoyage. Pour supprimer les filtres des baffles, enlever le panneau Centre en tirant le panneau vers l'avant de la hotte, soulever pour la supprimer. Déplacer les filtres au centre du capot, déflecteur de tirer vers l'avant de la hotte et sortez. Pour retirer le bac à graisse, faites glisser le plateau vers le haut de la hotte et sortez. Filtres propres souvent pour des performances optimales.
CONSIGNES DE SÉCURITÉ Lire et conserver ces Instructions AVERTISSEMENT : Pour réduire le risque d'incendie, de chocs électriques ou de blessures, respectez les points suivants : Utilisez cet appareil que de la façon prévue par le fabricant. Si vous avez des questions, contactez le fabricant. Avant de réparer ou de nettoyer l'appareil, coupez l'alimentation électrique hors tension au panneau électrique et verrouillez Service moyens de déconnexion pour éviter sa marche accidentellement.
Mail warranty card to: Imperial Cal Products ATTN: Warranty Department 425 Apollo St. Brea, CA 92821 Or visit our website to complete warranty registration: www.imperialhoods.com Rev. 5/17 Please keep receipt. Proof of original purchase date is needed to obtain service under warranty. Warranty card can be submitted via our website at: www.imperialhoods.com or by mail.