Operation Manual

Clock / timer display
The clock/timer display will vary
depending on which symbol the
triangle is underneath
–
the time of day m,
–
the minute minder time set l,
–
the start time f,
– the duration g,
– the end time )
The triangle - in the oven and
clock/timer displays
Each time the temperature or
clock/timer selector button is pressed
the symbols representing the
settings which you can change are
displayed one after the other in the
bottom line of the display.
Press the relevant button repeatedly
until the triangle - is under the symbol
of the function required.
If the display shows triangle - under a
symbol
–
flashing, alterations can be made to
the settings of the function selected.
–
lit up, the function will be displayed,
but changes cannot be made to it.
Whilst triangle - is flashing, use the
– or + buttons immediately to make any
changes:
–
Pressing + increases the value
shown or engages the function.
–
Pressing – reduces the value shown
or switches the function off.
The triangle - will flash for approx.
5 seconds.
Settings can only be changed with
the – or + buttons while it is flashing.
If this period has elapsed you will
have to call up the required symbol
again.
Each press of the – or + button alters:
– the oven temperature in 5 °
increments,
– the core temperature in 1 °
increments, if the roast probe is
being used,
– time by the minute.
Holding the button pressed in speeds
up the changes in the display.
Controls
23