Imperial Cal. Products, Inc. Installation Instructions & Warranty Information 425 Apollo Street Brea, CA 92821 www.imperialhoods.
Imperial Cal Products, Inc. Read Before Starting Installation! Inspect your range hood prior to installing! Any cosmetic defects must be reported to us prior to installation. Once this hood is installed, ICP will NOT accept any responsibility for any cosmetic blemishes, scratches or dents in the Canopy. Save all original packaging if you wish to return for any reason! FIRST: Check your local building and electrical codes.
Imperial Cal Products, Inc. Powered Liners Installation Detail: 1. MODELS: MODELS: MODELS: C2000SD2 C2000BP C2000PS1-TW C2000SD4 C2000BP1-TW C2000PSB (Baffle Filters) * C2000BP1 C2000PS C2000PS1-TWB (Baffle Filters)* (C2000PS-28 & C2000PS1-TW28) Scribe line below top of cabinet to meet with bottom of hood. Repeat on the opposite cabinet. (Figure 1) 2. Position 4” x 11 1/4” x 3/4” wood block flat on side of cabinet with end of filler block against wall and secure with screws. Remove Filters. 3.
Imperial Cal Products, Inc. Powered Liners Installation Detail Continued: C2000SD C2000SD2-NV 7/8" Electrical 3/4" 2" 7" 5/8” 1/2" 12 " Back C2000BP 2-1/4” 2-1/8" 4" 3/ 9- 3/4" 4" " /4 -3 26 " /8 -3 V 46 -N & D2 " S /8 -3 00 40 C20 ", /8 D4, 3 34 & S ", /8 D2 -3 S 28 000 C2 18 -1 /8 " C2000BP1 5/8” 1/2" 7" 4" /4" -3 26 7/8" 12 Electrical 8" " 1/ 1- Back /4" -3 26 , /8" -3 28 22 -1 /4" C2000BP1-TW *C2000PSB - Top box dimension is 6” high.
Imperial Cal Products, Inc. Powered Liners Installation Detail Continued: Re-Circulating, (Non-Vented) Series: C2000SD2-NV For use when unable to terminate exhaust ducting to outside the structure. Figure 1: View from rear of the canopy. Figure 1 Included Not Included Canopy Exit Figure 2 4” x 10” Cover Face Plate Figure one shows the included elbow transition from 7” diameter round to 3 1/4” x 10” rectangular.
Imperial Cal Products, Inc. To order replace parts or schedule service please call our office at (800) 851-4192 or use our website… www.imperialhoods.com. PARTS: When ordering Parts we need the following information: ! Model Number (not serial number) found on UL label inside hood. ! Exact dimensions (in the case of filters) You can find the model number on the inside of your hood on our UL label.
Imperial Cal Products, Inc. Maintenance & Warranty Information This product has the simplest of cleaning requirements. To remove Baffle Filters, remove center panel by pulling panel toward the front of the hood, lift up to remove. Move filters to the center of the hood, pull baffle towards the front of the hood and lift out. To remove grease tray, slide tray to the top of the hood and lift out. Clean filters often for the best performance. How often depends on amount and type of cooking.
SAFETY INSTRUCTIONS Read and Save These Instructions Warning: To reduce the risk of fire, electrical shock or injury to persons, observe the following: A. Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock Service Disconnecting Means to prevent power from being switched on accidentally.
