Installation Sheet

Imperial Cal Products, Inc.

Powered Liners Installation Detail Continued:

Figure 1:

Figure one shows the included elbow

transition from 7” diameter round to 3

1/4” x 10” rectangular. This transition

is used to return the filtered air back to

inside the kitchen either through the

canopy face of if applicable the soffit

above. The customer must provide the

appropriate length of straight 7” round

ducting that connects the hood exhaust

to the elbow transition.

Figure 2

Figure two shows a typical air exit

terminating through the canopy face. A

customer supplied, decorative 4” x 10”

to finish off the cut out opening.

Figure 3

Figure three shows a typical air exit

terminating through the soffit face

directly above the hood canopy. Again

the customer must provide a 4” x 10”

Re-Circulating, (Non-Vented) Series: C2000SD2-NV

For use when unable to terminate exhaust ducting to outside the structure.

View from rear of the canopy.

Canopy Exit

Soffit Exit

Included

Not Included

NOTE: The C2000 NV Unit comes supplied with charcoal filters that will accumulate the cooking

grease and over time decrease the hoods performance. The amount and style of cooking will

dictate how often the filters should be replaced. This type of filter is designed for replacement

only. Contact Imperial to purchase proper replacement filters. The C2000SD2-NV requires one

50 Watt Halogen (Par 20) flood light that must be purchased separately.

Figure 1

Figure 2

4” x 10” Cover

Face Plate

4” x 10” Cover

Face Plate

Figure 3