Installation Sheet

Island Installation Details Cont:
5. Installing the Hood: Caution - DO NOT handle hood using Motor Mounts as
Gripping Points!
 Remove all the mesh filters located at the bottom of
your hood.
 Remove the BLACK tape that holds the damper blades
closed. (It is NOT recommended to use two (2) dampers
during installation. You have the option to use an
external damper or use the existing damper already on
our unit.) Make sure not to obstruct damper operation
and properly seal all duct connections with duct tape.
 Slim Line & Contemporary: Lift hood and position the
support frame between the two mounting brackets that
have been factory installed on the hood top. Secure
with four #8 1” screws by installing them through the
pre-drilled holes in the brackets, into the frame.
 Pyramid: Remove the Power Liner assembly (C2000)
by unscrewing the four mounting nuts and washers
located at each corner of the hood. Install the canopy
(shell) in the same manner as the Slim Line canopy.
Re-install the C2000 back into the
canopy.
 Connect duct work to the vent opening located at the
top of the hood.
6. Electrical Connections:
 Verify that power is turned off at source. Remove
junction box cover from the underside of the hood at the
power supply location. Feed house electrical lead
through the pre-punched hole located in the hood top,
then into the hood junction box. Connect appropriate
wire leads, secure with wire nuts and re-install junction
box cover.
7. Decorative Stack Cover:
 Verify the actual dimensions between hood top and
ceiling. Test fit the stack by positioning the front por-
tion of the stack cover in place at all four sides of the
support frame. Adjust height if required. Now remove
the double face tape covering from the stack support
tabs located next to the canopy mounting brackets
and also from the two front vertical edges on the three
sided portion of the stack cover.
 Set the stack cover in place around the support frame,
making sure of a tight joint at the top of the canopy.
Now secure the cover piece using the four screws pro-
vided. The cover is designed to “Float” where it meets
the ceiling. Should a small gap exist, it may be
caulked or hidden with a trim molding of your choice.
8. Finalized Installation:
 You may now remove the protective clear covering,
and re-install the aluminum mesh bottom filters. Reconnect your electrical supply
and test the operation of your motors and lights.