INSTALLATION GUIDE STATIC AND STATIC WITH MOTORIZED DAMPERS MODELS Horizontal series • MODEL SHTM • MODEL SHMTM • MODEL SHTM • MODEL SHMTM
Redefining Indoor Air Quality Solutions worthy of nature... TM GreentekTM Peace of Mind Limited WARRANTY All GreentekTM products are backed by the best limited warranty in the industry, for your peace of mind. You benefit from a lifetime warranty on the core, and a 5 year warranty on all other components. So you can breathe easy. About Us Imperial Air Technologies Inc.
STATIC AND STATIC WITH MOTORIZED DAMPERS MODELS 1.Ventilation Needs Determine Your Ventilation Needs installation How much fresh air do I need? Good air quality is based in part on the capacity of the home’s ventilation system. Usually, the HRV’s capacity is measured in CFM (Cubic Feet per Minutes) or L/s (Liters per Seconds) of fresh air being distributed in the living space. The Room Count Calculation or the Air Change per Hour Method shows you how to determine your ventilation needs. A.
3. Typical Installation (continued) Exhaust from supply and supply in return Exhaust from the supply and supply in return 6’ installation Make sure that the Supply air from HRV is at least 3 feet from the forced air system. Can be different from a region to an other. You should check with your local code or the forced air system’s manufacturer.
STATIC AND STATIC WITH MOTORIZED DAMPERS MODELS 3. GreentekTM HRV Systems Installation Kit Included in the installation kit: • 4 Collars • 1 Condensation Drain Line • 1 Drain Adapter with Nut • 2 Tie Wraps (30”) • 16 screws (#10 x 5/8”) • 4 screws (#10 x 1”) Figure 3.1 Pull out the inserts first then use the straps to lift the unit out of the box Figure 3.2 Installation kit is shipped inside the unit Figure 3.3 Installation kit 4. Finding a suitable installation area for HRV.
5.Installation of the HRV The SPMTM system is supplied with the HRV to allow one person mounting of unit. SPM TM attachment system The entire line of GreentekTM HRV products is designed for installation by a single person. “Single Person MountingTM” will enable you to save time and effort by offering you a variable attachment system and maximizing your basement space. figure 5.
STATIC AND STATIC WITH MOTORIZED DAMPERS MODELS 7. Insulated Flex ISF TM collar system (Patent Pending Technologies) Quick and simple to install thanks to our revolutionary “Insert Slide and FixTM” collar system. The “ISFTM” collar system by GreentekTM enables you to manipulate duct within your reach and then insert the collar to the HRV by sliding it in place, for a better and quicker installation. figure 6.
PROFESSIONAL, DELUXE AND FURNACE MODELS 8. Motorized Damper Assembly (Model SHMTM Only) Motorized Damper balancing system The HRV must be balanced properly in order to operate at maximum performance. GreentekTM products are equiped with balancing damper to help eliminate the risks. figure 8.5 figure 8.1 Motorized damper kit figure 8.2 Assembling damper motor figure 8.3 Closing damper figure 8.
STATIC AND STATIC WITH MOTORIZED DAMPERS MODELS 9.Condensation Drain Line Sloped Drain Pan drainage system GreentekTM HRV units are equipped with an easy-access sloped drain pan. Excess condensation that might accumulate inside the unit migrate to the centre of the drain pan to be evacuated. figure 9.1 Hand screw the drain adapter Insert the threaded drain adapter thru the bottom of the HRV and hand tighten the plastic nut supplied with the drain kit.
. Outside Hoods GreentekTM TIPS to installer figure 10.2- To make your installation easier use our double collar to install your flex pipe with the outside hooks. 72” 18” figure 10.1 Locating Outside Hoods Greentek to installer TM INFO We manufacture a wide selection of : • Insulated Flexpipe • Hoods figure 10.2 Insert vinyl duct over the hooks. Fix the collar on the floor joist. GreentekTM TIPS to installer Extend the sheet metal sleeve 1.5” inside the home.
STATIC AND STATIC WITH MOTORIZED DAMPERS MODELS 11. Balancing Damper Maximizing the unit’s performance installation The HRV must be balanced properly in order to operate at maximum performance and avoid problems. Balancing the Unit installation Balancing the unit is an important step in the installation of the HRV. The operation consists of measuring and regulating the volume of fresh air from outside passing through the unit is equal with the exhaust air from home.
. Controls (Model SHMTM Only) Control The GreenThinkerTM model control is offered with features making your ventilation system simple, easy to operate and backed by a 5 year limited warranty. GreenThinker model RD-1model TM DEHUMIDISTAT Features • Dehumidistat to select the humidity level Greentek’s RD-1 modelTM allows the homeowner to select the indoor humidity level.
STATIC AND STATIC WITH MOTORIZED DAMPERS MODELS 14. Maintenance When should I Service my HRV? service and accessories HEAT RECOVERY CORE UNIT Once a year or as needed, vacuum the four surfaces, let soak in warm water for three hours, then spray rinse and let dry. FILTERS Four times a year or as needed, vacuum the filters. Replace filters once a year. figure 14.1 Slide Out the Filters figure 14.2 Vacuum the Filters figure 14.3 Slide out the Energy Core figure 14.
16. Wiring Diagram (Model SHMTM Only) OPTION 1 OPTION 2 Note to installer OPTION 3 On older thermostats, energizing the R and G terminals at the forced air system has the effect of energizing the Y terminal at the thermostat and therby activating the coolong system. If you identify this type of thermostat, you must use Option 3.
STATIC AND STATIC WITH MOTORIZED DAMPERS MODELS 17. Specification and Technical Information Easy Access Door removable top hinge door SPECIFICATIONS SH 0.8 SH 0.12 Size Heat exchanger (L x H x W) CFM Type of heat exchanger 237/8"x211/2"x113/8" 12" x 12" x 10" 80* cross-flow (Polypropylene) 237/8"x211/2"x161/2" 12" x 12" x 15" 120* cross-flow (Polypropylene) SPECIFICATIONS SHM 0.8 SHM 0.
ITEM # 100320 REF 0503-004 Protect the natural world from harmful activities of humans Imperial Air Technologies inc. 500 Ferdinand Blvd. Dieppe, NB Canada E1A 6B9 Toll free: 1 888 724-5211 Visit us at: www.greentek.