Owner's Manual

STEP 2 (See Diagram 2)
A.) Attach the Butterfly Base Frame (#3) to the Main Support Frame (#1) from the bottom.
Secure it with two M10 x 3” Allen Bolts (#98), one Bracket (#2), four Ø ¾” Washers
(#107), and two M10 Aircraft Nuts (#110).
B.) Slide fourteen Weight Plates (#73) onto the two Guide Rods (#20). Make sure all the
holes on the Weight Plates are facing the back of the machine and the grooves are all on
the bottom. Each Plate weights approximately 10 lbs.
C.) Insert the Selector Rod (#25) into the center of the stack.
D.) Slide the Selector Stem (#72) onto the Guide Rods. Secure the Selector Stem to the
Selector Rod with one M12 x 2 3/8” Allen Bolt (#83) and one M12 Aircraft Nut (#111).
E.) Attach the ring on the Weight Selector Pin (#82) onto the Selector Rod. Insert the Weight
Selector Pin into the selected hole to select the numbers of Weight Plates for exercise.
Please refer to the Weight Resistance Chart in page 43.
11