Owner's Manual

STEP 9 (See Upper Cable Loop & Diagram 9)

A.) Attach the 142” Upper Cable (#44) to the open pulley bracket under the Upper Frame (#17).

Attach a Pulley (#59) to the open bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#95), two

Ø ¾” Washers (#107), and one M10 Aircraft Nut (#110). Make sure the ball stopper on the

Cable is underneath the Upper Frame.

B.) Draw the Cable over the Pulley to the second open bracket under the Upper Frame. Attach a

Pulley to the open bracket. Secure it with one M10 x ¾” Allen Bolt (#95), two Ø ¾” Washers

(#107), and one M10 Aircraft Nut (#110).

C.) Draw the Cable around the Pulley then to the upper opening on the Front Press Base (#18).

Attach a Pulley to the opening. Secure it with one M10 x 5 1/8” Allen Bolt (#103), two Ø ¾”

Washers (#107), two 1 7/8” Spacers (#21), and one M10 Aircraft Nut (#110). Note the

direction of the Bolt shown in Diagram-9-1- C.

D.) Draw the Cable around the Pulley to the upper opening on the Vertical Frame (#7). Attach a

Pulley to the opening. Secure it with one M10 x 3 ½” Allen Bolt (#100) and one M10 Aircraft

Nut (#110).

E.) Draw the Cable around the Pulley to the lower opening on the Front Press Base. Repeat

Procedure C above to install a Pulley.

F.) Draw the Cable around the Pulley to the lower opening on the Vertical Frame. Repeat

Procedure D above to install a Pulley. Draw the Cable around the Pulley then downward.

G.) Attach the Cable to a Double Floating Pulley Bracket (#16). Attach a Pulley to the Bracket.

Secure it with one M10 x 1 ¾” Allen Bolt (#95), two Ø ¾” Washers (#107), and one M10

Aircraft Nut (#110). Draw the Cable around the Pulley then upward to the open bracket under

the middle of Upper Frame. Let the Double Floating Pulley Bracket hanging for now.

H.) Attach a Pulley to the open bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#95), two Ø ¾”

Washers (#107), and one M10 Aircraft Nut (#110).

I.) Draw the Cable to the open bracket under the rear of Upper Frame. Repeat Procedure H

above to install a Pulley.

J.) Draw the Cable around the Pulley then downward between the two Guide Rods (#20) to the

Selector Rod (#25). Attach a M12 Nut (#112) to the head of Cable. Thread the head of the

Cable firmly into the Selector Rod.