Owner's Manual

STEP 11 (See Leg Press Cable Loop and Diagram 11)

A.) Connect one end of 123” Leg Press Cable (#47) to the Pulley pre-installed on the Leg

Press Rear Frame (#31). Draw the Cable over the Pulley along the Leg Press Base Frame

to the other end.

B.) Attach the Cable to the open bracket on the Leg Press Rear Base Frame. Attach a Pulley

to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#95), two Ø ¾” Washers (#107),

and one M10 Aircraft Nut (#110).

C.) Draw the Cable around the Pulley then upward to the Short Chain (#88) installed in Step-

10. Attach the Cable to the Hook (#89). After completion of all Cables installation, come

back to this step to adjust the tension of the Cable system. Move up the Hook one joint on

Short Chain to increase the tension. Move down the Hook to loose the tension.

D.) Draw the other end of the Cable along the Leg Press Base Frame (#38) to the open

bracket on the Leg Press Base Frame.

E.) Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#95), two Ø ¾”

Washers (#107), and one M10 Aircraft Nut (#110).

F.) Draw the Cable under the Pulley upward to the other open bracket. Secure a Pulley to the

bracket with one M10 x 3” Allen Bolt (#98) and one M10 Aircraft Nut (#110).

G.) Draw the Cable over the Pulley then downward to another open bracket on the Leg Press

Base Frame. Attach a Pulley to the bracket. Repeat Procedure E above to install a Pulley.

H.) Draw the Cable around the Pulley then upward to the open bracket. Secure the head of

Cable to the bracket with one M10 x 1” Allen Bolt (#131), two Ø ¾” Washers (#107), and

one M10 Aircraft Nut (#110).