Owner's Manual

STEP 4 (See Diagram 4)

A.) Attach the Leg Developer (#7) to the bracket on the Leg Developer Holder (#1). Secure it

with a Leg Developer Axle (#47), two M10 x 5/8” Allen Bolts (#74), and two Ø ¾” Washers

(#83).

B.) Insert two Foam Roll Tubes (#28) halfway through the holes on the Leg Developer and Leg

Developer Holder. Push four Foam Rolls (#61) onto the Tubes from both ends. Plug four

Foam Roll End Caps (#60) into the ends.

C.) Place the Seat (#38) onto the Seat Support (#16). Secure it with two M8 x 2 1/8” Allen Bolts

(#76) and Ø 5/8” Washers (#84).

D.) Attach the Arm Curl Pad (#40) to the Arm Curl Stand (#10). Secure it with two M8 x 5/8”

Allen Bolts (#77) and Ø 5/8” Washers (#84). Insert the Arm Curl Stand into the top opening

on the Leg Developer Holder. Secure it with a Lock Knob (#43).

DIAGRAM 4