Owner's Manual
Table Of Contents
- BEFORE YOU BEGIN...................................................................................... 1
- IMPORTANT SAFETY NOTICES..................................................................... 2
- HARDWARE PACK……….....…....................................................................... 4
- ASSEMBLY INSTRUCTIONS........................................................................... 7
- WEIGHT RESISTANCE CHART....................................................................... 28
- PARTS LIST………………………………………………………………………….. 29
- WARRANTY.................................................................................................… 30
- ORDERING PARTS......................................................................................... 30
- WARNING LABEL REPLACEMENT
- HARDWARE PACK
- HARDWARE PACK
- ASSEMBLY INSTRUCTION
- Slide the Right Butterfly (#10) onto the right axle on the Butterfly Base (#13).
- Insert the Butterfly Handle (#9) into the pivot on the Right Butterfly. Secure it with one M10 x ¾” Allen Bolt (#103) and ( 1 ¼” Washer (#70) from the bottom.
- Repeat Procedures A and B above to install the other side. Do not over tighten the Bolts. Make sure the Handles are able to swivel.
- DIAGRAM 5
- Station
- Leg Developer
- Hip/Thigh
- Station
- Leg Developer
- Hip/Thigh
STEP 2 (See Diagram 2)
A.) Attach the Upper Frame (#1) onto the two Guide Rods (#17). Secure it with two M10 x
¾” Allen Bolts (#103) and ∅ ¾” Washers (#111). DO NOT tighten the Bolts yet.
B.) Place the Upper Frame onto the Vertical Frame (#4). Secure it with two M10 x 2 5/8”
Carriage Bolts (#106), one 4 ¾” x 2 ¾” Bracket (#25), two ∅ ¾” Washers (#111), and
two M10 Aircraft Nuts (#109).
C.) Securely tighten all Nuts and Bolts previously installed.
D.) Attach the Seat Support Frame (#7) to the Vertical Frame (#4). Secure it with two M10 x
2 5/8” Carriage Bolts (#106), one 4 ¾” x 2 ¾” Bracket (#25), two ∅ ¾” Washers (#111),
and two M10 Aircraft Nuts (#109).
E.) Attach the Leg Developer (#8) to the bracket on the Seat Support Frame. Secure it with
one Leg Developer Axle (#19), two M10 x ¾” Allen Bolts (#103), and two Ø ¾” Washers
(#111). Do not over tighten the Bolts. Make sure the Leg Developer is able to swivel.
9