Owner's Manual
Table Of Contents
- BEFORE YOU BEGIN...................................................................................... 1
- IMPORTANT SAFETY NOTICES..................................................................... 2
- HARDWARE PACK……….....…....................................................................... 4
- ASSEMBLY INSTRUCTIONS........................................................................... 7
- WEIGHT RESISTANCE CHART....................................................................... 28
- PARTS LIST………………………………………………………………………….. 29
- WARRANTY.................................................................................................… 30
- ORDERING PARTS......................................................................................... 30
- WARNING LABEL REPLACEMENT
- HARDWARE PACK
- HARDWARE PACK
- ASSEMBLY INSTRUCTION
- Slide the Right Butterfly (#10) onto the right axle on the Butterfly Base (#13).
- Insert the Butterfly Handle (#9) into the pivot on the Right Butterfly. Secure it with one M10 x ¾” Allen Bolt (#103) and ( 1 ¼” Washer (#70) from the bottom.
- Repeat Procedures A and B above to install the other side. Do not over tighten the Bolts. Make sure the Handles are able to swivel.
- DIAGRAM 5
- Station
- Leg Developer
- Hip/Thigh
- Station
- Leg Developer
- Hip/Thigh
STEP 3 (See Diagram 3)
A.) Attach the Front Press Base (#2) to the Upper Frame (#1). Secure it with one 6
¾” Front Press Base Axle (#29), two Ø 1 ¼” Washers (#70), and two M10
Aircraft Nuts (#109).
B.) Attach the Front Press (#3) to the Front Press Base. Secure it with one 7 ½”
Front Press Axle (#30), two Ø1 ¼” Washers (#70), and two M10 Aircraft Nuts
(#109).
C.) Thread the 4” T-shaped Lock Pin (#78) into the hole on the Front Press to
obtain the desired Front Press position.
D.) Attach the Backrest Board (#89) to the Backrest Support Frame (#5). Secure it
with two M8 x 1 5/8” Allen Bolts (#113) and Ø 5/8” Washers (#112).
E.) Attach the Backrest Support Frame (#5) to the Vertical Frame (#4). Secure it
with one M10 x 4 ¼” Allen Bolt (#95), two ∅ ¾” Washers (#111), and one M10
Aircraft Nut (#109).
F.) Thread the 6 ¼” T-shaped Lock Pin (#77) into the hole on the side of the
Vertical Frame to obtain the desired Backrest position.
10