Owner's Manual
Table Of Contents
- BEFORE YOU BEGIN...................................................................................... 1
- IMPORTANT SAFETY NOTICES..................................................................... 2
- HARDWARE PACK……….....…....................................................................... 4
- ASSEMBLY INSTRUCTIONS........................................................................... 7
- WEIGHT RESISTANCE CHART....................................................................... 28
- PARTS LIST………………………………………………………………………….. 29
- WARRANTY.................................................................................................… 30
- ORDERING PARTS......................................................................................... 30
- WARNING LABEL REPLACEMENT
- HARDWARE PACK
- HARDWARE PACK
- ASSEMBLY INSTRUCTION
- Slide the Right Butterfly (#10) onto the right axle on the Butterfly Base (#13).
- Insert the Butterfly Handle (#9) into the pivot on the Right Butterfly. Secure it with one M10 x ¾” Allen Bolt (#103) and ( 1 ¼” Washer (#70) from the bottom.
- Repeat Procedures A and B above to install the other side. Do not over tighten the Bolts. Make sure the Handles are able to swivel.
- DIAGRAM 5
- Station
- Leg Developer
- Hip/Thigh
- Station
- Leg Developer
- Hip/Thigh
STEP 4 (See Diagram 4)
A.) Attach the Seat Pad (#88) to the Seat Post (#6). Secure it with two M8 x 1 5/8” Allen
Bolts (#113) and Ø 5/8” Washers (#112).
B.) Insert the Seat Post into the opening on the Seat Support Frame (#7). Thread the 3
3/8” T-shaped Lock Pin (#73) into the nut on the Seat Support Frame to lock the
Seat at desired height.
C.) Insert one Foam Tube (#23) halfway through the hole on the Leg Developer (#8).
Push two Foam Rolls (#86) onto the Foam Tube from both ends. Plug two Foam Roll
End Caps (#59) into the Ends.
D.) Attach the Leg Machine Frame (#31) to the Rear Base Frame (#15). Secure it with
two M10 x 3 5/8” Allen Bolts (#96), one 5 ½” x 2” Bracket (#26), four Ø ¾” Washers
(#111), and two M10 Aircraft Nuts (#109).
E.) Attach the Rotating Cam Plate (#32) to the Leg Machine Frame (#31). Align the
holes and insert the axle on the Lever Frame (#33) through the holes. Secure it with
one Ø 1 ¼” Washer (#70) and one M12 Aircraft Nut (#110). Do not over tighten the
nut. The Lever Frame needs to swivel freely on the pivot.
F.) Adjust and secure the Lever Frame (#33) to the Cam (#32) with a 4” T-shaped Lock
Pin (#78).
G.) Insert the axle on the Lever Frame Handle (#34) into the opening on the Lever
Frame (#33). Secure it with one Ø 1 ¼” Washer (#70) and M10 Aircraft Nut (#109).
H.) Slide a 7” Swivel Tube Sleeve (#38) onto the tube on the Lever Frame Handle (#34).
I.) Push one Ø 4” Large Foam Roll (#58) onto Sleeve. Plug one Foam Roll End Cap
(#59) into the end of Handle.
J.) Slide one Foam Tube (#23) halfway through the hole on the Leg Machine Frame
(#31). Secure it with one M6x 3/8” Screw (#108). Push the 6 7/8” Grips (#67) onto
the Tube.
12