Owner's Manual
Table Of Contents
- BEFORE YOU BEGIN...................................................................................... 1
- IMPORTANT SAFETY NOTICES..................................................................... 2
- HARDWARE PACK……….....…....................................................................... 4
- ASSEMBLY INSTRUCTIONS........................................................................... 7
- WEIGHT RESISTANCE CHART....................................................................... 28
- PARTS LIST………………………………………………………………………….. 29
- WARRANTY.................................................................................................… 30
- ORDERING PARTS......................................................................................... 30
- WARNING LABEL REPLACEMENT
- HARDWARE PACK
- HARDWARE PACK
- ASSEMBLY INSTRUCTION
- Slide the Right Butterfly (#10) onto the right axle on the Butterfly Base (#13).
- Insert the Butterfly Handle (#9) into the pivot on the Right Butterfly. Secure it with one M10 x ¾” Allen Bolt (#103) and ( 1 ¼” Washer (#70) from the bottom.
- Repeat Procedures A and B above to install the other side. Do not over tighten the Bolts. Make sure the Handles are able to swivel.
- DIAGRAM 5
- Station
- Leg Developer
- Hip/Thigh
- Station
- Leg Developer
- Hip/Thigh
STEP 9 (See Diagram 9)
A.) Connect the Lat Bar (#24) to the 167” Upper Cable (#42) with two Hooks (#90) and one
Short Chain (#75).
B.) Attach the Abdominal Strap (#85) to the U-shaped Cable Connector (#48) on the 217”
Lower Cable (#40) with a Hook (#90).
C.) Connect the Shiver Bar (#22) to the 217” Lower Cable with two Hooks and a Long Chain
(#76).
DIAGRAM 9
24