Owner's Manual
Table Of Contents
- BEFORE YOU BEGIN...................................................................................... 1
- IMPORTANT SAFETY NOTICES..................................................................... 2
- HARDWARE PACK……….....…....................................................................... 4
- ASSEMBLY INSTRUCTIONS........................................................................... 7
- WEIGHT RESISTANCE CHART....................................................................... 28
- PARTS LIST………………………………………………………………………….. 29
- WARRANTY.................................................................................................… 30
- ORDERING PARTS......................................................................................... 30
- WARNING LABEL REPLACEMENT
- HARDWARE PACK
- HARDWARE PACK
- ASSEMBLY INSTRUCTION
- Slide the Right Butterfly (#10) onto the right axle on the Butterfly Base (#13).
- Insert the Butterfly Handle (#9) into the pivot on the Right Butterfly. Secure it with one M10 x ¾” Allen Bolt (#103) and ( 1 ¼” Washer (#70) from the bottom.
- Repeat Procedures A and B above to install the other side. Do not over tighten the Bolts. Make sure the Handles are able to swivel.
- DIAGRAM 5
- Station
- Leg Developer
- Hip/Thigh
- Station
- Leg Developer
- Hip/Thigh
STEP 10 (See Diagram 10)
A.) Attach one end of 75” Hip-Thigh Cable (#39) to the bracket on the Rotating Cam Plate (#32).
Secure it with one M10 x 1” Allen Bolt (#102), two Ø ¾” Washers (#111), and one M10 Aircraft
Nut (#109).
B.) Attach two Medium Pulleys (#87) to the pulley bracket on the Leg Machine Frame (#31). Attach a
Double Pulley Bracket (#101) to the two Large Pulleys. Align the holes and secure them with two
M10 x 1 ¾” Allen Bolts (#99), four Ø ¾” Washers (#111), and two M10 Aircraft Nuts (#109).
C.) Draw the Cable between the two Large Pulleys and downward to the opening on the bottom of
the Frame. Attach a Pulley (#44) to the opening. Secure Pulley to the opening with one M10 x 3
3/8” Allen Bolt (#97), two Pulley Bushings (#53), and one M10 Aircraft Nut (#109).
D.) Draw the Cable underneath the Pulley to the open bracket behind the Frame. Install a Pulley with
one M10 x 1 ¾” Allen Bolt (#99), two Ø ¾” Washers (#111), and one M10 Aircraft Nut (#109).
E.) Draw the Cable around the Pulley then upward to the Single Floating Pulley Bracket (#18)
previously installed in Step-7. Secure the end of Cable to the bracket with M10 x 1” Allen Bolt
(#102), two Ø ¾” Washers (#111), and one M10 Aircraft Nut (#109).
25