Marcy Home Gym User's Manual
Table Of Contents
- BEFORE YOU BEGIN....................................................................................……….. 1
- IMPORTANT SAFETY NOTICE...................................................................……….. 2
- HARDWARE PACK……….....….....................................................................……….. 4
- ASSEMBLY INSTRUCTIONS.........................................................................……….. 6
- PARTS LIST………………………………………………………………………………….. 23
- RESISTANCE CHART………….......................................................................………. 24
- WARRANTY.................................................................................................…………. 25
- ORDERING PARTS.......................................................................................………… 25
- HARDWARE PACK
- ASSEMBLY INSTRUCTION
- STEP 7 (See Diagram 7)
- PARTS LIST
- KEY NO. DESCRIPTION Q’ty
- Station
- Low Pulley
- Leg Developer
- Leg Press
- Station
- Low Pulley
- Leg Developer
- Leg Press
STEP 2 (See Diagram 2)
A.) Slide two Ø 2 ½” x 1” Rubber Bumpers (#65) onto the Guide Rods (#18). Attach
the two Guide Rods onto the Weight Stack Frame (#17). Secure the bottom of
Guide Rods with two M10x 1” Allen Bolts (#82) and two Ø ¾” Washers (#91).
B.) Pull the top of the two Guide Rods off the Weight Stack Frame. Slide 14 Weigh
Plates (#59) onto the Guide Rods. Make sure the deep groove on the Weight
Plates are all facing the machine and downward.
C.) Insert the Selector Rod (#24) through the center hole on the Weight Plates. Slide
the Selector Stem (#37) onto the Guide Rods.
D.) Push the top of Guide Rods back. Secure them to the Weight Stack Frame with
two M8 x 1 5/8” Allen Bolts (#86), four two Ø 5/8” Washers (#92), and two M8
Aircraft Nuts (#95).
8