Owner's Manual

STEP 2 (See Diagram 2)

A.) Attach the holes on the Upper Frame (#1) onto the Guide Rods (#11). Place the Upper

Frame onto the Vertical Frame (#4).

B.) Secure the Upper Frame to the Guide Rods with two M10 x 1” Allen Bolts (#64) and Ø ¾”

Washers (#73).

C.) Secure the Upper Frame to the Vertical Frame with two M10 x 2 3/8” Carriage Bolts (#58),

one 1 ¾” x 4 ¾” Bracket (#18), two  ¾” Washers (#73), and two M10 Aircraft Nuts (#70).

D.) Securely tighten all Nuts and Bolts previously installed in Step-1 and Step-2.

E.) Attach the Leg Developer (#7) to the open bracket on Seat Support (#5). Secure it with one

M12 x 3 1/8” Allen Bolt (#67), two  1” Washers (#74), and one M10 Aircraft Nut (#71).

F.) Attach Seat Pad (#23) to Seat Support. Secure it with four M8 x 5/8” Allen Bolts (#60) and

four Ø 5/8” Washers (#72).

G.) Attach Backrest Board (#24) to Vertical Frame. Secure it with two M8 x 2 1/8” Allen Bolts

(#63) and two Ø 5/8” Washers (#72).