Owner's Manual
Table Of Contents
- BEFORE YOU BEGIN...................................................................................…. 1
- IMPORTANT SAFETY NOTICES..................................................................…. 2
- HARDWARE PACK……….....…....................................................................…. 4
- ASSEMBLY INSTRUCTIONS........................................................................…. 6
- EXPLODED DIAGRAM………………………………………………………………. 12
- PARTS LIST...................................................................................................…. 13
- OPERATING NOTES………………………………………………………………… 14
- WARRANTY.................................................................................................……. 18
- ORDERING PARTS.....................................................................................……. 18
- A.) Insert the Sliding Frame (#41) through the Seat Support (#43). Use the Quick Release Knob (#42) to lock the Seat Support at selected position.
- B.) Attach the Sear Support to Rear Support Frame (#40) and secure them with eight M8 x ⅝” Allen Bolts (#21).
- C.) Place the Seat Pad (#45) onto the Seat Support. Secure the Seat Pad with four M x ⅝” Allen Bolts (#21).
- A.) Attach the Handle (#13) to Seat Support (#43). Securely tighten it with two M8 x 1 ⅝” Carriage Bolts (#28), two Ø 5/8” Curved Washers (#5), and two M8 Acorn Nuts (#29).
- B.) Attach the Backrest Board (#44) to the Seat Support. Secure it with four M8 x ⅝” Allen Bolts.
- MUSCLE TONING
- WEIGHT LOSS

© IMPEX INC. www.impex-fitness.com 15
COMPUTER
AUTO START / STOP
When exercise starts, the monitor will automatically turn on and display the progress. When
exercise stops, the monitor will automatically turn off after 4 minutes to save energy.
MODE-
1. Press “MODE” key, will automatically scan Time, Speed, Distance, Calories, and ODO for
every 4 seconds.
2. When Computer is in Scan mode, press “MODE” key to select Time, Distance, or Calories
function.
SET-
Press SET key to set the targeted exercises value of Time, Distance, and Calories.
RESET-
Press RESET key to reset Time, Distance, or calories value to zero.
DISPLAY:
Time Display the elapsed time. Max value is up to 99:59
Speed Display the current speed in miles per hour.
Distance Display the distance traveled in Miles. Max value is 99.99 miles.
Calories Display the calorie consumption in cal.
(ODO) Odometer Display the accumulation of distance from previous and current exercises.
Max value is 9999 miles.
REPLACE BATTERY:
1. Remove the battery cover on the back of the computer.
2. Requires two 1.5V (AA) batteries.
3. Make sure the batteries are installed correctly and the polarities are correct.
4. If the display is not clear or only partial segments appeared, remove the batteries and wait for
15 seconds before re-install them.
5. The battery life is approx. 3 months under normal usage.
6. When the batteries are removed, all the functional values will reset to zero.
7. Batteries are not included.
Note:
Please note all values on this computer are approximate and they are for comparison
purpose only. Do not use these values for any medical or rehabilitation purpose.










