Owner's Manual
Table Of Contents
- BEFORE YOU BEGIN...................................................................................…. 1
- IMPORTANT SAFETY NOTICES..................................................................…. 2
- HARDWARE PACK……….....…....................................................................…. 4
- ASSEMBLY INSTRUCTIONS........................................................................…. 6
- EXPLODED DIAGRAM………………………………………………………………. 12
- PARTS LIST...................................................................................................…. 13
- OPERATING NOTES………………………………………………………………… 14
- WARRANTY.................................................................................................……. 18
- ORDERING PARTS.....................................................................................……. 18
- A.) Insert the Sliding Frame (#41) through the Seat Support (#43). Use the Quick Release Knob (#42) to lock the Seat Support at selected position.
- B.) Attach the Sear Support to Rear Support Frame (#40) and secure them with eight M8 x ⅝” Allen Bolts (#21).
- C.) Place the Seat Pad (#45) onto the Seat Support. Secure the Seat Pad with four M x ⅝” Allen Bolts (#21).
- A.) Attach the Handle (#13) to Seat Support (#43). Securely tighten it with two M8 x 1 ⅝” Carriage Bolts (#28), two Ø 5/8” Curved Washers (#5), and two M8 Acorn Nuts (#29).
- B.) Attach the Backrest Board (#44) to the Seat Support. Secure it with four M8 x ⅝” Allen Bolts.
- MUSCLE TONING
- WEIGHT LOSS
© IMPEX INC. www.impex-fitness.com 8
STEP-3
A.) NOTE: Extra help may be needed to hold the Front Post (#4) while connecting the cables
and wires.
B.) Attach the Front Post (#9) to the Main Frame (#1). Connect the Middle Computer Wire (#34) from
the bottom of the Front Post to the Lower Computer Wire (#35) from the Main Frame.
C.) Pull the tension connector from the Upper Tension Cable (#32) and slide in between the opening
on the connector on the Lower Tension Cable (#33). Pull the Upper Tension Cable upward and
slide the wire through the slot on the bracket.
D.) Drop down the Upper Tension Cable so the fitting sits firmly on top of the bracket.
E.) Secure the Front Post to the Main Frame with four M8 x 5/8” Allen Bolts (#21) and four Ø 5/8”
Curved Washers (#5).
F.) Attach the Front Right and Left Handle (#11 & #12) to the Front Post. Secure each Handle with
two M8 x ⅝” Allen Bolt (#21) and two Ø 5/8” Curved Washers (#5).
G.) Remove the four M5 x ⅜” Philips Screws from the Computer (#10). Slide the Computer onto Front
Post. Secure it with the four Screws.