User's Manual

Copyright © 2010, Impinj, Inc. i
Products Covered by this Guide
This guide pertains to readers with the following part numbers:
Table i: Speedway Reader Part Numbers
Reader
Communication Code
Part Number
Speedway R220
FCC
IPJ-REV-R220-USA1M1
Speedway R420
FCC
IPJ-REV-R420-USA1M1
Speedway R220
ETSI
IPJ-REV-R220-EU11M1
Speedway R420
ETSI
IPJ-REV-R420-EU11M1
Speedway R220
Various
IPJ-REV-R220-GX11M1
Speedway R420
Various
IPJ-REV-R420-GX11M1
Speedway R640
FCC
IPJR640
Speedway R640
ETSI
IPJ-REV-R640-EU1M1
Speedway R640
Various
IPJ-REV-R640-GX11M1
Federal Communications Commission (FCC) Compliance
This equipment was tested and complies with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a commercial
environment. This equipment generates, uses, and can radiate radio frequency
energy. If not installed and used in accordance with the instructions, the
equipment may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation
and cause harmful interference to radio or television reception. To determine if
this equipment causes harmful interference to radio or television reception, turn
the equipment off and on. You are encouraged to try to correct the interference
by one or more of the following:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or a qualified radio/TV technician for assistance.
Caution: Changes to this product or modifications not expressly approved by
the party responsible for compliance could void your authority to operate per FCC
Part 15.
Industry Canada (IC) Compliance
Operation is subject to the following two conditions:
(1) This device may not cause interference.