User's Manual

ManualsBrandsImpinj ManualsElectronicsRFID Integrated Reader, IPJR640

Speedway Revolution Installation and Operations Guide Octane 4.4

Appendix A: Region Specific Information

Power

Speedway Revolution may only be operated with Impinj-approved antennas

and can radiate no more than 36 dBm EIRP per FCC Part 15.247 regulations.

The Speedway Revolution output power may be increased to provide the

maximum allowable EIRP subject to a maximum conducted power allowance

of 30 dBm at the antenna connector. The maximum allowable output power

of the reader can be set to satisfy both the conductor and radiated maximum

criteria. The expression for the maximum reader power setting is:

Maximum power setting (in dBM) = the Smaller of:

(36 – Composite Antenna Gain (in dBM))

(30 + Cable Loss (in dBM),

where the composite antenna gain comprises the maximum linear antenna gain

in dBi minus any cable loss between the reader and antenna in dB. Approved

antenna vendors, model numbers, and associated gain are listed in the next

section.

 Note: The composite antenna gain comprises the maximum linear antenna gain

in dBi minus any cable loss between the reader and antenna in dB. Approved

antenna vendors, model numbers, and associated gain are listed in the next

section.

Approved Antennas

• Laird Technologies model number S9028PCL/R (left- or right-hand CP),

with integrated 8 foot pigtail to RP-TNC male connector; 6 dBi composite

gain

• Impinj model number IPJ-A0301-USA (Mini-Guardrail) with SMA female

connector; -15 dBi gain

• Impinj model number IPJ-A0310-USA (Threshold-T Antenna) with 12 inch

integrated pigtail to BNC male connector, 6 dBi composite gain.

• Impinj model number IPJ-A0400-USA, CSL CS-777-2 (Brickyard) with

7 foot integrated pigtail to RP-TNC male connector; 2 dBi composite gain

• Impinj model number IPJ-A0401-USA or IPJ-A0402-USA (both Guardwall)

with 6 foot integrated pigtail to RP-TNC male connector; 6 dBi composite

gain

• MA/COM MAAN-000246-FL1 integrated RFID floor-mounted stand

(multiple configurations available, 2 or 4 antennas left-hand and right-

hand CP) with 8 foot integrated pigtail to RP-TNC male connector; 6 dBi

composite gain

• MA/COM MAAN-000246-WL1 integrated RFID wall-mounted stand

(multiple configurations available, 2 antennas left-hand and right-hand

CP) with 8 foot integrated pigtail to RP-TNC male connector; 6 dBi

composite gain

• MTI MT-262006/TLH (left-hand CP) or MT-262006/TRH (right-hand CP)

with RPTNC female connector (antennas available in IP54 or IP67 ratings);

6 dBi gain

• MTI MT-262013/NLH (left-hand CP) or MT-262013/NRH (right-hand CP)

with Ntype female connector (antennas available in IP54 or IP67 ratings);

4.5 dBi gain