User's Manual

Speedway Revolution Installation and Operations Guide Octane 4.4

(2) This device must accept any interference, including interference that may

cause undesired operation of the device.

This device has been designed to operate with the antenna(s) listed on page 32

that have a maximum gain of 6 dB. Antennas not included in this list or having a

gain greater than 6 dB are strictly prohibited for use with this device. The

required antenna impedance is 50 ohms. To reduce potential radio interference to

other users, the antenna type and its gain should be chosen so that the

equivalent isotropically radiated power (EIRP) is not more than that permitted for

successful communication. The term “IC” before the radio certification number

only signifies that Industry of Canada technical specifications were met.

CE Marking and European Economic Area

(EEA)

RFID devices designed for use throughout the EEA must have a maximum

radiated transmit power of 2W ERP in the frequency range of 865.6–867.6 MHz.

For other EEA restrictions on RFID device use, please refer to the Impinj

Declaration of Conformity (DoC) located at support.impinj.com.

Before You Begin

Warning: Please read this document in its entirety before operating the

Speedway Revolution reader, as serious personal injury or equipment damage

may result from improper use. Unauthorized opening of the Speedway Revolution

reader enclosure voids the warranty. To safeguard personnel, be sure to position

all antenna(s) according to the specified requirements for your regulatory region.

For details, see “Appendix A: Information Specific to Regions of Operation” on

page 33.