Operations Guide
1 Products Covered by this Guide
This guide pertains to readers with the following part numbers and communication codes:
Impinj R700 RAIN RFID Reader Part Numbers
Reader Communication Code Part Number Features
R700 FCC IPJ-R700-141 Four ports, mounting bracket
R700 ETSI IPJ-R700-241 Four ports, mounting bracket
R700 FGX IPJ-R700-341 Four ports, mounting bracket
R700 JP IPJ-R700-441 Four ports, mounting bracket
1.1 Federal Communications Commission (FCC) Compliance
This equipment was tested and complies with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, the equipment may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation
and cause harmful interference to radio or television reception. To determine if this equipment causes harmful
interference to radio or television reception, turn the equipment o and on. You are encouraged to try to
correct the interference by one or more of the following:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or a qualied radio/TV technician for assistance.
Caution: Changes to this product or modications not expressly approved by the party responsible
for compliance could void your authority to operate per FCC Part 15.
Attention: Les modications apportées à ce produit ou modications pas expressément approuvés
par la partie responsable de la conformité peuvent annuler votre droit à utiliser par FCC Part 15.
Note: Industry Canada (IC) Compliance
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation
of the device.
This device has been designed to operate with the antenna(s) listed in Information Specic to Regions of
Operation that have a maximum gain of 6 dB. Antannas not included in this list or having a gain greater
than 6 dB are strictly probibited for use with this device. The required antenna impedence is 50 ohms.
To reduce potential radio interference with other users, the antenna type and its gain should be chosen
so that the equivalent isotropically radiated power (EIRP) is not more than that permitted for sucessful
communication. The term ”IC” before the radio certication number only signies that Industry of Canada
technical specications were met.
3