Operations Guide
Table Of Contents
- PRODUCTS COVERED BY THIS GUIDE
- INTRODUCTION
- INTRODUCTION TO IMPINJ R700 RAIN RFID Reader
- INSTALLING AND CONNECTING IMPINJ R700 RAIN RFID READER
- Impinj R700 RAIN RFID Reader Ports and LEDs
- Installing and Connecting the Reader
- Detailed Installation Procedures
- Step 1: Position the Impinj R700 RAIN RFID Reader and (optionally) Mount the Reader
- To Mount the Impinj R700 RAIN RFID Reader
- Step 2: Connect the Antenna(s) to the Impinj R700 RAIN RFID Reader
- To Connect the Antenna(s) to the Reader
- Step 3: Power the Reader
- Step 4: Connect the Impinj R700 RAIN RFID Reader to the Network
- To Connect the Impinj R700 RAIN RFID Reader to the Ethernet Network
- To Troubleshoot Ethernet Network Connections
- To Connect the Impinj R700 RAIN RFID Reader to Your PC Over a Serial Connection
- CONFIGURING AND MONITORING IMPINJ R700 RAIN RFID READER
- UPGRADING THE IMINJ R700 RAIN RFID READER FIRMWARE
- TROUBLESHOOTING
- APPENDIX A: INFORMATION SPECIFIC TO REGIONS OF OPERATION
- APPENDIX B: SUBMITTING DIAGNOSTIC DATA FOR ANALYSIS BY IMPINJ TECHNICAL SUPPORT
- Notices
Impinj R700 RAIN RFID Reader
Installation and Operations Guide
version 6.2.0
14
One short GREEN
blink
LLRP active, but no LLRP connection
Blinking ORANGE
Inventory active, blinking rate increases with an
increased number of
tags in the Reader FOV
Table: Antenna Status LED Patterns
LED State
Reader State
OFF
Antenna inactive
Solid GREEN
Antenna actively transmitting
LED Behavior in Scenarios for Startup, Upgrade, Detection, Inventory, and
LLRP
The tables in this section describe the LED behavior for various reader operation scenarios.
Table: Startup (Power On), Normal Completion
Reader Operation
LED
Expected Behavior
Power applied,
attempting to start boot
code
Power:
Status:
Solid red
Off
Bootloader calling
firmware image
Power:
Status:
Solid green
Off
Bootloader completed
successfully, Reader is
ready
Power:
Status:
Solid green
Solid green
Table: Startup (Reset), Normal Completion
Reader Operation
LED
Expected Behavior
Default Restore button
pressed
Power:
Status:
Turns off
Off
Default Restore button
pressed for 3 seconds
Power:
Blinks once (red), indicates a
configuration default restore
will occur.
Default Restore button
pressed for 10 seconds
Power:
Blinks twice (red), indicates a
factory default restore will
occur. Resets Reader