Operations Guide
Table Of Contents
- PRODUCTS COVERED BY THIS GUIDE
- INTRODUCTION
- INTRODUCTION TO IMPINJ R700 RAIN RFID Reader
- INSTALLING AND CONNECTING IMPINJ R700 RAIN RFID READER
- Impinj R700 RAIN RFID Reader Ports and LEDs
- Installing and Connecting the Reader
- Detailed Installation Procedures
- Step 1: Position the Impinj R700 RAIN RFID Reader and (optionally) Mount the Reader
- To Mount the Impinj R700 RAIN RFID Reader
- Step 2: Connect the Antenna(s) to the Impinj R700 RAIN RFID Reader
- To Connect the Antenna(s) to the Reader
- Step 3: Power the Reader
- Step 4: Connect the Impinj R700 RAIN RFID Reader to the Network
- To Connect the Impinj R700 RAIN RFID Reader to the Ethernet Network
- To Troubleshoot Ethernet Network Connections
- To Connect the Impinj R700 RAIN RFID Reader to Your PC Over a Serial Connection
- CONFIGURING AND MONITORING IMPINJ R700 RAIN RFID READER
- UPGRADING THE IMINJ R700 RAIN RFID READER FIRMWARE
- TROUBLESHOOTING
- APPENDIX A: INFORMATION SPECIFIC TO REGIONS OF OPERATION
- APPENDIX B: SUBMITTING DIAGNOSTIC DATA FOR ANALYSIS BY IMPINJ TECHNICAL SUPPORT
- Notices
Impinj R700 RAIN RFID Reader Installation and Operations
G id
version 6.2.0
23
To Configure the Reader’s Network Settings
1. Open the RShell console. For more information, see the procedure “To connect a Impinj R700
RAIN RFID Reader to your PC over a serial connection” in section 5.3.4.
2. View the Reader’s current configuration settings by entering the show network summary
command at the RShell command prompt as shown in the following example:
> show network summary
Status='0,Success'
PrimaryInterface='eth0
‘ActiveInterface='eth0'
Hostname='impinj-00-00-B9'
connectionStatus='Connected'
ipAddressMode='Dynamic'
ipAddress='10.0.10.41'
‘ipMask='255.255.0.0'
ReaderAddress='10.0.0.10'
broadcastAddress='10.0.255.255'
LLAStatus='enabled'
3. Configure the appropriate TCP/IP parameters for your environment. The applicable commands
are:
• Setting H
ostname
> config network hostname <HOSTNAME>
• Setting Static IP Address
> config network ip static <IP ADDRESS><NETMASK>
<READER>
Note: The IP address is required, however the other parameters are optional. The default value
is used if an optional parameter is omitted from the ip command.
• Enabling DHCP
> config network ip dynamic
• Configuring NTP Servers
> config network ntp add <NTP SERVER ADDRESS>
4. After successfully configuring all required network settings, connect the Reader to the network
through the Impinj R700 RAIN RFID Reader Ethernet port.
RF Configuration