Operations Guide
Table Of Contents
- PRODUCTS COVERED BY THIS GUIDE
- INTRODUCTION
- INTRODUCTION TO IMPINJ R700 RAIN RFID Reader
- INSTALLING AND CONNECTING IMPINJ R700 RAIN RFID READER
- Impinj R700 RAIN RFID Reader Ports and LEDs
- Installing and Connecting the Reader
- Detailed Installation Procedures
- Step 1: Position the Impinj R700 RAIN RFID Reader and (optionally) Mount the Reader
- To Mount the Impinj R700 RAIN RFID Reader
- Step 2: Connect the Antenna(s) to the Impinj R700 RAIN RFID Reader
- To Connect the Antenna(s) to the Reader
- Step 3: Power the Reader
- Step 4: Connect the Impinj R700 RAIN RFID Reader to the Network
- To Connect the Impinj R700 RAIN RFID Reader to the Ethernet Network
- To Troubleshoot Ethernet Network Connections
- To Connect the Impinj R700 RAIN RFID Reader to Your PC Over a Serial Connection
- CONFIGURING AND MONITORING IMPINJ R700 RAIN RFID READER
- UPGRADING THE IMINJ R700 RAIN RFID READER FIRMWARE
- TROUBLESHOOTING
- APPENDIX A: INFORMATION SPECIFIC TO REGIONS OF OPERATION
- APPENDIX B: SUBMITTING DIAGNOSTIC DATA FOR ANALYSIS BY IMPINJ TECHNICAL SUPPORT
- Notices
Impinj R700 RAIN RFID Reader Installation and Operations
G id
version 6.2.0
35
green.
4. Remove the USB drive from the “USB Host” port and reboot the Reader.
During the upgrade process, the Reader will attempt to append information to a status.log file in the
impinj/revolution/upgrade directory. The status.log file is intended to provide an audit trail for the
upgrade of one or more Readers.
If the firmware upgrade process fails, the Power LED will blink red. Remove the USB drive, reboot the
Reader, and check the “status.log” file for the reason of the failure.
Upgrading the Firmware Through the Impinj Management Web UI
You can also upgrade the firmware by accessing the Impinj Reader Management web page, and running
the upgrade from the management web page.
1) Connect to the reader using a web browser http://<reader name or IP address>. Examples:
http://impinj-10-00-DD or http://10.0.10.44
2) Log in to the reader using the default user name and password:
user name: root
password: impinj
3) Click Choose File, and then select the firmware upgrade .upg file.
4) Click Upgrade
5) After the upgrade is complete, click Reboot.