Operations Guide
Table Of Contents
- PRODUCTS COVERED BY THIS GUIDE
- INTRODUCTION
- INTRODUCTION TO IMPINJ R700 RAIN RFID Reader
- INSTALLING AND CONNECTING IMPINJ R700 RAIN RFID READER
- Impinj R700 RAIN RFID Reader Ports and LEDs
- Installing and Connecting the Reader
- Detailed Installation Procedures
- Step 1: Position the Impinj R700 RAIN RFID Reader and (optionally) Mount the Reader
- To Mount the Impinj R700 RAIN RFID Reader
- Step 2: Connect the Antenna(s) to the Impinj R700 RAIN RFID Reader
- To Connect the Antenna(s) to the Reader
- Step 3: Power the Reader
- Step 4: Connect the Impinj R700 RAIN RFID Reader to the Network
- To Connect the Impinj R700 RAIN RFID Reader to the Ethernet Network
- To Troubleshoot Ethernet Network Connections
- To Connect the Impinj R700 RAIN RFID Reader to Your PC Over a Serial Connection
- CONFIGURING AND MONITORING IMPINJ R700 RAIN RFID READER
- UPGRADING THE IMINJ R700 RAIN RFID READER FIRMWARE
- TROUBLESHOOTING
- APPENDIX A: INFORMATION SPECIFIC TO REGIONS OF OPERATION
- APPENDIX B: SUBMITTING DIAGNOSTIC DATA FOR ANALYSIS BY IMPINJ TECHNICAL SUPPORT
- Notices
Impinj R700 RAIN RFID Reader Installation and Operations
G id
version 6.2.0
39
Warning: Pressing the Default Restore button for
10 seconds or more will cause a factory default
restore to occur. The factory default restore
removes the Reader’s custom application
partition (CAP) if one exists. The Reader returns
to the original, factory shipped state. It is
important to avoid accidentally removing the
CAP. There may be situations where CAP removal
is necessary.
Avertissement: Appuyer sur le Défaut Bouton
Restaurer pendant 10 secondes ou plus entraîne
une restauration. D’usine par défaut de se
produire restaurer la valeur par défaut supprime
partition d’application personnalisée du lecteur
(CAP) s’il existe. Le lecteur retourne à l’état usine
original expédié. C’est important d’éviter de
supprimer accidentellement la CAP. Il peut y avoir
des situations où l’enlèvement de la CAP est
nécessaire.