Users Manual

Integration instructions for host product manufacturers according to KDB 996369 D03 OEM

Manual v01

2.2 List of applicable FCC rules

47 CFR Part 15 Subpart C §15.247

47 CFR Part 15 Subpart F §15.519

2.3 Specific operational use conditions

External antenna: “Decawave WB003”

Operating temperature: -40 to 85 °C

Supply voltage: 2.8 – 3.6V

2.4 Limited module procedures

not applicable

Not a “limited module”.

2.5 Trace antenna designs

The antenna trace must be kept as short as possible. The antenna feed of the PCB antenna

“Decawave WB003” must be placed as close as possible to pin 31 of the radino40 module. The PCB

antenna must be placed on the TOP layer of the carrier PCB.

2.6 RF exposure considerations

The radino40 DW1000 BLE and UWB transmitters meets all requirements for SAR or RF Exposure,

intended or unintended, under FCC rules. The BLE radio falls well below the limit determined for

<5mm separation (a “body-worn” device) and, for a UWB radio operating above 6GHz, there are

currently no exposure limits specified.

If the final host / module combination is intended for use as a portable device the host manufacturer

is responsible for separate evaluations/approvals for the SAR requirements from FCC Part 2.1093 and

RSS-102.

2.7 Antennas

Model No. of antenna: Decawave WB003

Type of antenna: Ultra-wideband Omni-directional Planar antenna, integrated on the carrier PCB

according to reference design.

The mounting of the antenna is fixed to the radio module and no other antenna should be used.

2.8 Label and compliance information

The final end product must be labeled in a visible area with the following

Contains FCC ID: 2AWXURADINO40DW1000

2.9 Information on test modes and additional testing requirements

Testing of the host product with all the transmitters installed is recommended, to verify that the host

product meets all the applicable FCC rules. The radio spectrum and RF Exposure is to be investigated

with all the transmitters in the final host product functioning to determine that no emissions exceed the

radino40 DW1000

PAGE 1
radino40 DW1000 Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01 2.2 List of applicable FCC rules 47 CFR Part 15 Subpart C §15.247 47 CFR Part 15 Subpart F §15.519 2.3 Specific operational use conditions External antenna: “Decawave WB003” Operating temperature: -40 to 85 °C Supply voltage: 2.8 – 3.6V 2.4 Limited module procedures not applicable Not a “limited module”. 2.5 Trace antenna designs The antenna trace must be kept as short as possible.
PAGE 2
highest limit permitted for any one individual transmitter as required by Section 2.947(f). A formal application for certification submission containing the results of this investigation is not required. The host manufacturer is responsible to ensure that when their product operates as intended it does not have any emissions present that are out of compliance that were not present when the transmitters were tested individually.