Operators Manual Owner manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 General Specifications
- 4 Sensor Specifications
- 5 Instrument Overview
- 6 System Components
- 7 Probe Setup
- 8 Communication Settings and Calibration
- Connect the Instrument to the Computer
- Connect the Instrument to Win-Situ 5 Software
- First Screen (Data Tab)
- Set Communication Outputs
- Modbus Setup
- SDI-12 Setup
- View and Record Data
- Calibrate and Set Up Sensors
- Set Parameter Units and Sentinel Values
- RDO Sensor Calibration
- Conductivity Calibration
- Pressure/Level
- pH/ORP Calibration
- 9 Controller Requirements and Connections
- 10 Care and Maintenance
- 11 Declaration of Conformity
800-446-1500 12 www.in-situ.com
Sensors
Sensors include optical RDO (Rugged Dissolved Oxygen), pH/ORP, conductivity,
pressure, and temperature.
1 Pressure sensor 76 m (250 ft)
2 pH/ORP sensor
3 Conductivity sensor
4 Temperature sensor
5 RDO Sensor
Cable
The cable includes a twist-lock connection to the instrument and a stripped-and-tinned
termination that must be wired to a controller. Cable length is customizable. Maximum
length is 1,219 m (4,000 ft) for Modbus output, and 60.9 m (200 ft) for SDI-12 output.
Win-Situ 5 Software
The Win-Situ 5 Software is used to calibrate the sensors and to configure the
instrument settings to communicate with a process controller or data logger. See the
Communication Settings and Calibration section for more details.