Operators Manual Owner manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 General Specifications
- 4 Sensor Specifications
- 5 Instrument Overview
- 6 System Components
- 7 Probe Setup
- 8 Communication Settings and Calibration
- Connect the Instrument to the Computer
- Connect the Instrument to Win-Situ 5 Software
- First Screen (Data Tab)
- Set Communication Outputs
- Modbus Setup
- SDI-12 Setup
- View and Record Data
- Calibrate and Set Up Sensors
- Set Parameter Units and Sentinel Values
- RDO Sensor Calibration
- Conductivity Calibration
- Pressure/Level
- pH/ORP Calibration
- 9 Controller Requirements and Connections
- 10 Care and Maintenance
- 11 Declaration of Conformity
800-446-1500 16 www.in-situ.com
Communication Settings and Calibration
Before you program the instrument to work with your PLC/SCADA system, you must set
appropriate communication settings using a TROLL Com, AC/DC converter, and Win-
Situ 5 Software. The software can also be used to calibrate sensors and to restore
factory calibration and communication settings.
Always wear appropriate personal protective equipment and use proper laboratory
technique when calibrating the sensors and operating the instrument.
Connect the Instrument to the Computer
Using a direct-connect TROLL Com Communication Device, powered with an AC/DC
power supply, you can connect the Aqua TROLL 400 to a computer running Win-Situ 5
Software version 5.6.22 or later.
Connect the Instrument to Win-Situ 5 Software
Install Win-Situ 5 Software from the Resources CD or from www.in-situ.com. Make
sure you select the check box that installs the USB drivers.
Open Win-Situ 5 Software and click the Connect button to connect to the
instrument.