Operators Manual Owner manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 General Specifications
- 4 Sensor Specifications
- 5 Instrument Overview
- 6 System Components
- 7 Probe Setup
- 8 Communication Settings and Calibration
- Connect the Instrument to the Computer
- Connect the Instrument to Win-Situ 5 Software
- First Screen (Data Tab)
- Set Communication Outputs
- Modbus Setup
- SDI-12 Setup
- View and Record Data
- Calibrate and Set Up Sensors
- Set Parameter Units and Sentinel Values
- RDO Sensor Calibration
- Conductivity Calibration
- Pressure/Level
- pH/ORP Calibration
- 9 Controller Requirements and Connections
- 10 Care and Maintenance
- 11 Declaration of Conformity
800-446-1500 18 www.in-situ.com
Screen Element Definition
The Sensors tab lists the sensors in the connected instrument,
along with their serial numbers and the dates of factory calibration
and user calibration. Use the buttons in this tab to calibrate sensors
that support user calibration and configure sensors that support
configuration.
The Device Setup tab allows access to instrument information and
settings such as instrument name, serial number, firmware version,
communication settings, diagnostics, and factory reset options.
Set Communication Outputs
The Device Setup Tab allows you to access communication settings, instrument
information and status, factory reset, diagnostics, and alarm setup. The instrument can
communicate via Modbus or SDI-12 protocols. However, the instrument can use only
one of the protocols at a time.