Operators Manual Owner manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 General Specifications
- 4 Sensor Specifications
- 5 Instrument Overview
- 6 System Components
- 7 Probe Setup
- 8 Communication Settings and Calibration
- Connect the Instrument to the Computer
- Connect the Instrument to Win-Situ 5 Software
- First Screen (Data Tab)
- Set Communication Outputs
- Modbus Setup
- SDI-12 Setup
- View and Record Data
- Calibrate and Set Up Sensors
- Set Parameter Units and Sentinel Values
- RDO Sensor Calibration
- Conductivity Calibration
- Pressure/Level
- pH/ORP Calibration
- 9 Controller Requirements and Connections
- 10 Care and Maintenance
- 11 Declaration of Conformity
800-446-1500 21 www.in-situ.com
View and Record Data
The Home tab allows you to view data for the parameters that have been enabled. Gray
values indicated that the instrument is not polling live data. To poll live data, click the
Play button.
Screen Element Definition
The Sites button allows you to add, edit, or delete a site. Non-
logging instruments such as the Aqua TROLL 400 do not use sites.
These icons allow you to view the memory and battery usage for an
instrument that includes internal logging. This is not applicable to
non-logging instruments that do not have batteries such as the Aqua
TROLL 400 and the RDO PRO-X Probe.
This icon allows you to view the logging status for an
instrument that includes internal logging. Disregard for the
Aqua TROLL 400.