Operators Manual Owner manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 General Specifications
- 4 Sensor Specifications
- 5 Instrument Overview
- 6 System Components
- 7 Probe Setup
- 8 Communication Settings and Calibration
- Connect the Instrument to the Computer
- Connect the Instrument to Win-Situ 5 Software
- First Screen (Data Tab)
- Set Communication Outputs
- Modbus Setup
- SDI-12 Setup
- View and Record Data
- Calibrate and Set Up Sensors
- Set Parameter Units and Sentinel Values
- RDO Sensor Calibration
- Conductivity Calibration
- Pressure/Level
- pH/ORP Calibration
- 9 Controller Requirements and Connections
- 10 Care and Maintenance
- 11 Declaration of Conformity
800-446-1500 24 www.in-situ.com
Set Parameter Units and Sentinel Values
You can set sentinel values and set units for parameters by selecting a parameter and
clicking the Setup Sensor button.
Screen Element Purpose
Parameter
This menu lists the parameters that are available for the
selected sensor.
Units
This drop-down list allows you to select units for the
parameter you selected.
Sentinel Offline
Value
This is a text field in which you can enter the value that
you want to see in the data when a sensor is unable to
communicate. After you have entered a value, click the
Set button to save it.
Configure
This button becomes active when you select a parameter
that includes additional configuration options. Click the
Configure button to view the additional options.
Check mark
Clicking the Check mark saves the changes you have
made in this screen.