Operators Manual Owner manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 General Specifications
- 4 Sensor Specifications
- 5 Instrument Overview
- 6 System Components
- 7 Probe Setup
- 8 Communication Settings and Calibration
- Connect the Instrument to the Computer
- Connect the Instrument to Win-Situ 5 Software
- First Screen (Data Tab)
- Set Communication Outputs
- Modbus Setup
- SDI-12 Setup
- View and Record Data
- Calibrate and Set Up Sensors
- Set Parameter Units and Sentinel Values
- RDO Sensor Calibration
- Conductivity Calibration
- Pressure/Level
- pH/ORP Calibration
- 9 Controller Requirements and Connections
- 10 Care and Maintenance
- 11 Declaration of Conformity
800-446-1500 4 www.in-situ.com
Conductivity Calibration 28
Pressure/Level 29
pH/ORP Calibration 30
9 Controller Requirements and Connections
32
Wiring Overview 32
Stripped-and-Tinned Cable 32
Power Connections 32
SDI-12 Wiring Diagram 33
Modbus Master RS485 Wiring Diagram 34
Modbus Master RS232 Wiring Diagram (Converter Required) 35
RS485 Network Guidelines 36
DB-9 Diagram 36
Communication Overview 36
10 Care and Maintenance
37
Maintenance Schedule 37
User-Serviceable Parts 37
O-rings 37
RDO Classic Sensor Cap Replacement 37
pH/ORP Sensor Replacement 37
Instrument Storage 37
Cleaning the pH/ORP Sensor 38
Remove Crystalline Deposits 38
Remove Oily or Greasy Residue 38
Remove Protein-Like Material or Slimy Film 39
Cleaning the RDO Sensor 39
Clean the Sensor Cap 39
Clean the Optical Window 39
Cleaning the Conductivity Sensor 39
Cleaning Procedure 1 40
Cleaning Procedure 2 40
Cleaning Procedure 3 40
Cleaning Procedure 4 40
11 Declaration of Conformity
41