Operators Manual Owner manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 General Specifications
- 4 Sensor Specifications
- 5 Instrument Overview
- 6 System Components
- 7 Probe Setup
- 8 Communication Settings and Calibration
- Connect the Instrument to the Computer
- Connect the Instrument to Win-Situ 5 Software
- First Screen (Data Tab)
- Set Communication Outputs
- Modbus Setup
- SDI-12 Setup
- View and Record Data
- Calibrate and Set Up Sensors
- Set Parameter Units and Sentinel Values
- RDO Sensor Calibration
- Conductivity Calibration
- Pressure/Level
- pH/ORP Calibration
- 9 Controller Requirements and Connections
- 10 Care and Maintenance
- 11 Declaration of Conformity
800-446-1500 8 www.in-situ.com
Dissolved Oxygen RDO Classic (Optical Sensor) Specifications
Accuracy ±0.1 mg/L; ±0.2 mg/L; ±10% of reading
Range
0 to 8 mg/L; 8 to 20 mg/L; 20 to 50 mg/L; Full operating
range: 0 to 50 mg/L
Resolution 0.01 mg/L
Sensor Type
Fixed with replaceable RDO Classic Sensor Cap (life: 1
year typical)
Response
Time
T90: <45 sec. T95: <60 sec.
Units of
Measure
mg/L, % saturation, ppm
Methodology
EPA-approved In-Situ Methods 1002-8-2009 1003-8-2009
1004-8-2009
ORP Sensor Specifications
Accuracy ±5.0 mV
Range ±1400 mV
Resolution 0.1 mV
Sensor Type Replaceable pH/ORP combo sensor
Response
Time
<15 sec.
Units of
Measure
mV
Methodology Std. Methods 2580