User Manual

8 11
12
1310
9
II-1 Recharge the Low Batter
II-14-1 During recharging
II-14-2 Fully charge
II-15 Turn off the Hands-free Car Kit
III. Maintenance and Safe Use
(please refer to Fig.2)
The LED of this Car Kit will flash red instead of green when the battery
are low. There will also be a short beep every 2 minutes. Please
connect the charger cable to the Car Kit.
The LED shows a steady red light if the Car Kit is off,
and the red light will dim once every second while the Car Kit is on.
When the batteries are fully charged, the red and green LED will be
exchanged.
A steady green LED represents the Car Kit is off and fully charged.
And a green LED dims once every 3 seconds represents the Car Kit is
on and fully charged.
When the hands-free Car Kit is on, press and hold S1 for 3 seconds. A
high tone followed by a low tone will indicate that the Car Kit is
powered off. Red LED will turn on for a second. At last LED will turn
off when the Car Kit is powered off.
Use dry cloth to clean hands-free Car Kit!
Recycle the batteries after their life time!
Do not expose the Car Kit to liquid or moisture!
Do not expose the Car Kit to fire or open flames!
When the battery level is too low, the hands-free ar it will
automatically power off. It cannot be powered on again unless the
batteries are charged after 5 minutes.
◎
◎
◎
◎
4ies
CKNotice:
IV Package Contents.
3AA
BatteriesRechargeable
x
Provided
Provided
Accessories
1 X Car Charger
Status
Disclaimer:
Talk time and stand-by time of the Car Kit will vary depending on mobile phone
model being used.
Note:
BQB, CE and FCC approved
The word mark and logos are owned by the SIG, Inc. and any use of such
marks by In-Tech Electronics Ltd. is under license. Other trademarks and trade names are
those of their respective owners.
Bluetooth
Bluetooth Bluetooth
Federal Communication Commission Interference Statement
-
-
-
-
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
.Use only rechargeable batteriesWarning: