User's Manual

8 Copyright © 2018 InCoax Networks AB. All rights reserved.
Confidential under NDA
2 Getting Started – Controller Web Interface
The Controller can be managed via the management port MGT . Please refer to Figure 3 where the front of
the Controller can be seen.
2.1 Accessing the Controller Web Interface
1. Connect a computer with an Ethernet cable to the Management port on the Controller,
marked MGT . (InCoax recommends using the cable type CAT5e as a minimum for best
performance.)
2. Set a static IP for your computer connection, for example 192.168.144.100 (or any IP
between 192.168.144.1 and 192.168.144.254 but not the same as the default IP address)
and Subnet Mask 255.255.255.0.
3. Open your web browser and go to the URL https://192.168.144.20. The web page in
Figure 4 will be displayed. Input the following to log in:
a. Default Username: incoax
b. Default Password: incoax
Figure 3 — The front of the Controller.
Figure 4 — The login page.
2.2 User Levels and Permissions
There are two different user levels with different purposes and permissions:

View Only : Demonstration and supervision. The View Only users can view some managed objects and
settings, but cannot add or change anything.

Admin : Controller and Modem management. The Admin users can add and change managed objects and
settings. This is the standard user level.
Table 2 gives a detailed view of what the two user levels are allowed to do.