User's Manual

ManualsBrandsIn:xtnd ManualsElectronicsNetwork Controller

Confidential under NDA

Table 12 — Description of the Priority parameters.

Term

Value

[Default Setting]

Definition

Type of Service Settings

Enable ToS On/Off [Off]

Enable/Disable if the Type of Service (ToS) field in IP-

header shall be used to control priority of the traffic. If ToS

is activated the priority of VLAN Pri-field (802.1p) is

overridden by the ToS settings.

Priority n: min / max

n = 0 - 7

Prio n / Min / Max.

0 / 0x0 / 0x1f

1 / 0x20 / 0x3f

2 / 0x40 / 0x5f

3 / 0x60 / 0x7f

4 / 0x80 / 0x9f

5 / 0xa0 / 0xbf

6 / 0xo0 / 0xdf

7 / 0xe0 / 0xff

The lower value of the ToS field is mapped according to

the priority in the VLAN Prio field. E.g. if the value in

“Priority 0: min” is 0 and “Priority 0: max” is 0x1f, all

packets with a ToS value between 0x0 and 0x1f will be

remarked with VLAN Prio 0 regardless of the initial VLAN

Prio value.

The default values are written in the column to the left.

Priority n: max

n = 0 - 7

0x0 – 0xff The higher limit of the ToS field, see above for Priority n.

Inbound Priority Mapping

Inbound Traffic class mapping

Internal P-bit N = 0 – 7

Traffic class

Q0 – Q3

The VLAN Prio value is mapped to the queue to which the

packet shall be transferred.

Inbound P-bit mapping

External P-bit N = 0 – 7

Internal P-bit

0 – 7 Remarking of incoming packets VLAN Prio value.

Apply Click to apply the settings.

Reset Click to discard the settings.

3.4.7

Advanced Settings

In Advanced settings it is possible to define the maximum Link speed on coax ports, setting of maximum unicast

(UC) capacity per Modem, and to decrease (UC Adjustment) the maximum unicast capacity per Modem for

each multicast group that is joined on the Modem.

1. In the main menu, hover over

MANAGEMENT

and click on

ADVANCED

. The web page is shown in

Figure 28

2. Default values

a. UC Adjustment: 0

b. UC Capacity: 1000 Mpbs

c. Link speed: 2500 Mpbs

d. Downstream BW: 2200 Mpbs

3. Change the default values and click on Update Advanced settings to save the new values.

Figure 28 — Advanced settings.