User's Manual

Copyright © 2018 InCoax Networks AB. All rights reserved. 31
Confidential under NDA
3.7.3 Network
The settings for the Network are one of the most important settings that allow management of the Controller.
The Controller can be managed by using a Management System via SOAP or simply to log in to the web
managing interface IP defined in the LAN settings. To enter this configuration:
In the main menu, hover over MANAGEMENT and click on NETWORK . The web page is shown in Figure 39 and
the parameters are described in Table 15 .
In the LAN settings there are the IP address and Subnet mask. The IP address is the main IP address which
allows to directly managing the Controller. Please refer to Getting started on page 8 before the Controller is
powered on.
The Management VLAN needs to be configured to be able to manage the Controller on the Trunk port.
Figure 39 — Network Settings.
Table 15 — Description of the Network settings Parameters.
Term Value Definition
Management Port Settings
IP address
User defined
network IP
The IP address of the node (if static). Used in conjunction with the
network mask and gateway fields as described below.
Subnet mask
User defined
network mask
The network mask used in conjunction with the node’s IP address.
Management VLAN Settings
SOAP Server /
Management VLAN
On/Off
Enable or disable access to the Controller through a tagged VLAN.
Check the checkbox to enable.
VLAN ID 1 - 4095 VLAN ID used in combination with Management VLAN.
IP address
User defined
network IP
IP address of the tagged VLAN interface. Used in conjunction with
the network mask described below.
Subnet mask
User defined
network mask
The network mask used in conjunction with the management
VLAN interface’s IP address.
Default gateway
User defined
gateway address
The gateway routing address used in conjunction with the node’s
IP address and network mask.
Apply Click to apply the settings.
Reset Click to discard the settings.
3.7.4 Time Settings
The date and time are mainly used for logs and may be important for proper event logging while
troubleshooting. There is an option to enter the time manually or automatically by an NTP-Server. The
Controller has to be able to connect to an NTP-server to update the time automatically.
In the main menu, hover over SETTINGS and click on TIME .