User's Manual

32 Copyright © 2018 InCoax Networks AB. All rights reserved.
Confidential under NDA
Figure 40 shows the Date and Time web page. Select Manual time (radio button) to set the time manually.
Enter the Date and Time and then click on the button Update .
Click on NTP Server (radio button) if you prefer that the time shall be set automatically and updated regularly.
Enter an NTP address for a server that you prefer to use. Use the parameters UTC Sign and UTC Offset to
compensate for an eventual time difference between the NTP server and the local time where the Controller is
located. Click in the field UTC Offset and select the number of hours from the list. Click on either of the radio
buttons for the UTC Sign if the offset shall be added or subtracted from the UTC time. (If the selected offset is
zero (0) then it does not matter if the sign is + or -.) Click on the button Update to save the settings.
The time is displayed in the footer of every page of the web GUI.
Figure 40 — Date and Time settings.
3.7.5 DNS Settings
Go to the DNS settings by hover over SETTINGS and click on DNS . Figure 41 shows the web page and the
descriptions of the parameters are found in Table 16 .
Figure 41 — DNS settings.
Table 16 — Description of the parameters for the DNS settings.
Term
Value
[Default Settings]
Definition
DNS 1 IP address [8.8.8.8] Domain name server 1
DNS 2 IP address Domain name server 2
DNS 3 IP address Domain name server 3
Apply Click to apply the settings.
Reset Click to discard the settings.
3.7.6 Management System Settings
The Controller can communicate with the Management System via a SOAP interface. The Controller needs
three parameters to achieve this. The IP address to Management System, Management System SOAP
Username, and Management System SOAP Password.