InBT-USB Bluetooth Dongle with USB interface Note; * This user manual describes methods and functions for using InBT-USB. * This product is a USB-type Bluetooth dong le which shall be assembled into the InBody (Body composition analyzer) communications via the USB port.
1. Overview This product is a USB-type Bluetooth dongle which shall be assembled into the USB port of the InBody (Body composition analyzer) for supporting data communications between the InBody and a personal computer, or external device has Bluetooth function. (1) Contents ① InBT-USB ② User’s Manual 2. Product Specifications USB 2.0 Full Speed support Bluetooth Version 2.1 + EDR, Class 1 Internal antenna Frequency band 2.
. Usag e of USB Type Bluetooth Dong le ※ The Bluetooth dongle, InBT-USB shall be assembled inside of the InBody (Body composition analyzer) as following picture by the Biospace and measured data will be transferred to a personal computer, or external device has Bluetooth function.
1) Driver Support Please install driver below in your OS imbedded board. The drivers listed below can be downloaded for free from the FTDI website (www.ftdichip.com). For more information on driver installation, visit the following site: http://www.ftdichip.com/Documents/InstallGuides.htm. (1) Virtual COM Port (VCP) Drivers You can use ASCII commands on a terminal program to perform various controls and configuration settings for InBT-USB.
2) Prog ram Setting s for OS imbedded board After installing the InBT-USB driver on a VCP (virtual COM port), you can use ASCII commands on a terminal program to perform various controls and configuration settings for InBT-USB. A terminal program is used for controlling or setting serial ports. The terminal program described in this manual is HyperTerminal provided with MS Windows. For more information on HyperTerminal, see the MS Windows Help. Figure 1.
- AT command This command is used for testing operation of the InBT-USB firmware. The command returns OK to indicate normal operation. AT OK - SET command This command is used for retrieving or modifying the InBT-USB settings. . Retrieving settings SET SET BT BDADDR 00:07:80:ff:ff:f1 SET BT NAME WT32-A SET BT CLASS 001f00 SET BT IDENT BT:47 f000 4.0.
. Modifying settings In the following example, the Bluetooth PIN code required for pairing is set to ¡°0000.¡± The code is saved in the non-volatile memory and only needs to be set once. SET BT AUTH * 0000 - INQUIRY command This command is used for searching for other Bluetooth devices available for pairing within the operating range.
5. Troubleshooting (1) If connection is not good, try pairing the devices again. (2) Transferring data in large volumes may result in low performance depending on the device connected. (3) This product uses same frequency bands as normal WiFi signals and is subject to ambient interferences. FCC Information This device complies with part 15 of the FCC Results.
¨Ï 1996-2012 Biospace Co., Ltd. All rights reserved. Notice This user’s manual cannot be copied, translated or transformed into different media without a prior written consent from Biospace Co., Ltd, according to the copyright laws. This user’s manual and product pertinent to this manual may have misprints or technical flaws, which can be modified without prior notice to the readers. Biospace is not liable for any damage caused by a failure to meet the requirements in this user’s manual. Biospace Co., Ltd.
“CAUTION : This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
