Instruction Manual

Precision Marking Rule
Marking:
Place your sharp pencil point or
scribe in the desired hole or slot,
then make your mark.
Measuring:
Use the scale lines on the edges to
make precision measurements.
Easy and Accurate
To mark with a 0.5mm
Mechanical Pencil: Just hold
the pencil vertically and draw a
short line in one of the slots, or
twist the pencil in a hole to mark
a dot.
To mark with a Wooden
Pencil: First, sharpen the pencil,
then twist the lead once or twice in
any one of the holes to give it an
ultra fine point ready for marking.
To mark with a Metal Scribe
or Center Punch: Any scribe
or center punch sharp enough to
fit through the holes can be used.
Use finger pressure ONLY to
mark a precisely located “dimple”
in soft materials such as wood,
paper, plastic, brass or aluminum.
DO NOT damage your preci-
sion rule by pounding the point
through the hole with a hammer.
When accuracy counts …
INCRA RULES!
18" Precision Marking Rule
Put YOUR Mark on Precision
Any rule can just
measure, but only
INCRA guarantees
YOUR mark of
precision on
everything you do!
INCRA RULES are available
in many other popular styles
and lengths.
Manufactured by:
Taylor Design Group
P.O. Box 810262
Dallas, Texas 75381
www.incra.com
INCRA is a Registered Trademark of Taylor Design Group, Inc.
©2013 Taylor Design Group, Inc.