User Manual

DQE @ 3 lp / mm 0.06 0.09

*The above specifications have been verified by INX; The physical

characterization of the systems was obtained with the standard beam

conditions RQA5 (in accordance with IEC 61267:1994).

A.1.7 Radio Waves

Wireless specifications for the flat panel detector and the access point are as

follows.

Item Specification

Wireless specification IEEE802.11 ac / a/g/n

Transmit frequency 5.2, 5.3, 5.6, 2.4 GHz

Antenna 2

Date rate 866Mbps (802.11ac)

Authentication WPA/WPA2-PSK

AP mode Work only in 2.4Ghz

- Note: Use of 2.4GHz: ch11 for N.America, ch13 for Europe (ETSI)

- Transmit frequencies available vary, depending on the country.

- Radio waves available outdoors vary, depending on the country where the

system is used.

- When the Yushan and any other wireless equipment are operating on the same

frequency channel in a hospital, it may take time to show an image on the image

processing unit monitor.

This equipment uses wireless LAN (WLAN) radios for transferring images. The

WLAN power levels and antenna configurations have been tested and certified

compliant through specific absorption rate (SAR) limit set by FCC testing with

separations as small as 0 cm between the panel antennas and human tissue.

A.1.8 Reliability and Lifetime

Item Specification unit

X-ray hardness 100 Gy

Expect service life 10 years