Instruction for Use

GB
17
Maintenance and care
Switching the appliance off
During cleaning and maintenance it is necessary to
disconnect the appliance from the electricity supply:
1. set the FREEZER OPERATION knob on
2. pull the plug out of the socket
! If this procedure is not followed, the alarm may sound.
This alarm does not indicate a malfunction. To restore
normal operation, it is sufficient to set the FREEZER
OPERATION knob on the desired value. To disconnect
the appliance, follow point 1 and 2.
Cleaning the appliance
 The external and internal parts, as well as the rubber
seals may be cleaned using a sponge that has been
soaked in lukewarm water and bicarbonate of soda or
neutral soap. Do not use solvents, abrasive products,
bleach or ammonia.
 The removable accessories may be soaked in warm
water and soap or dishwashing liquid. Rinse and dry
them carefully.
 The back of the appliance may collect dust which can
be removed by delicately using the hose of a vacuum
cleaner set on medium power. The appliance must be
switched off and the plug must be pulled out before
cleaning the appliance.
Avoiding mould and unpleasant odours
 The appliance is manufactured with hygienic materials
which are odour free. In order to maintain an odour
free refrigerator and to prevent the formation of stains,
food must always be covered or sealed properly.
 If you want to switch the appliance off for an extended
period of time, clean the inside and leave the doors
open.
Holiday function
If you are going on holiday, you do not have to switch
the appliance off; it features a low-energy function which
optimises the temperature of the refrigerator
compartment to suit the products stored inside it (you
may, for example, wish to protect cosmetics and beauty
products from the heat). The freezer temperature must
be set to the minimum value in order to preserve the
food.
To enable the function: set
the REFRIGERATOR
OPERATION knob on
HOLIDAY (see diagram).
A double acoustic signal
informs you when it has
been enabled. A single
acoustic signal informs
you when it has been
disabled.
Replacing the l Odour filter
The filter should be replaced after approximately 6-8 months
from when it is activated. This period may vary depending on
the type of food that is stored. For information on where a
replacement filter may be purchased, contact Assistance (see
Assistance). To replace the filter, follow the instructions (see
diagrams A and B).
Replacing the light bulb
To replace the light bulb in the refrigerator compartment,
pull out the plug from the electrical socket. Follow the
instructions below.
Access the light bulb by removing the cover as
indicated in the diagram.
Replace it with a similar light bulb within the power
range indicated on the cover (10W).
A
B